BEGA 50086.2 Wall Light LED Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
50086.2 Wall Light LED
Instruction Manual 50 086.2
Technical amendments reserved
50086.2 Wall Light LED
Wall luminaire for indoor use
Instructions for use
Application
Free-radiating wall luminaire · indoor luminaire made of hand-blown opal glass, satin matt and metal housing, for all lighting tasks.
Product description
Metal housing, finish Stainless steel
Hand-blown opal glass, satin matt 2 mounting holes ø 5 mm
Distance apart 287 x 55 mm
Connecting terminals 2.5@
Earth conductor connection
Installation surface 315 x 86 mm
LED-Module for mains voltage 220-230 V 50/60 Hz
BEGA Thermal Switch®
Temporary thermal shutdown to protect temperature-sensitive components
Safety class I
– Safety mark
– Conformity mark
Weight: 1.6 kg
This product contains light sources of energy efficiency class(es) G
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we
recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.
Lamp
| Luminaire connected wattage | 14.8 W |
|---|---|
| Rated temperature | ta = 25 °C |
| Ambient temperature | ta max = 40 °C |
50 086.2 K3
| Module designation | 2x LED-0662/930 |
|---|---|
| Colour temperature | 3000 K |
| Colour rendering index | Ra > 90 |
| Module luminous flux | 1320 lm |
| Luminaire luminous flux | 1003 lm |
| Luminaire luminous efficiency | 67,8 lm / W |
Installation
LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during
installation or relamping.
Loosen knurled nuts and replace glass from luminaire housing.
Pull silicone sleeves over the wires, make earth connection and electrical
connection to the terminals.
Fix luminaire housing with enclosed or any other suitable fixing material onto
the mounting surface.
Place glass with its opening over the LED module and fix it hand tight onto
the luminaire housing by means of the knurled nuts.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
Defective glass must be replaced.
Replacing the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted. The module can be replaced by a
qualified electrician or a comparably qualified person using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Defective glass must be replaced.
Close the luminaire.
Spares
| Spare glass | 11 003 198 .0R G |
|---|---|
| LED module 3000 K | LED-0662/930 |
BEGA Gantenbrink-Leuchten KG
Postfach 31 60
58689 Menden
info@bega.com
www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>