BEGA 50264.1 LED Wall Luminaire for Indoor Use Instruction Manual

Table of Contents

Product Description	Metal housing, finish colour white
Hand-blown Opal Glass	Satin matt
Cable Entry	1 entry for through-wiring
Connecting Terminals	2.5@
LED-Module Voltage	Mains voltage 220-230 V, 50/60 Hz
Weight	1.2 kg
Energy Efficiency Class	F

Installation:
- LED components are high-quality electronic components. Avoid touching the light output opening of the LED directly during installation or relamping.
- Lead the main supply cable through the cable entry of the luminaire base.
- Fix the luminaire base with the enclosed or any other suitable fixing material onto the mounting surface. Use the gasket rings supplied.
- Establish an earth conductor connection and make the electrical connection to the terminals.
- Take into account that glass and metal have different expansion rates. Place the glass into the luminaire base and fix the set screws hand-tight. After tightening, loosen the set screws for half a turn to allow the glass to move.
Replacing the LED Module:

The designation of the LED module is noted on

Shielded wall luminaire · indoor luminaire made of hand-blown opal glass, satin matt with a metal shield, for many lighting tasks.
The light emits upwards and downwards.

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation.
If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
To achieve additional protection against e. g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.

50 264.1 K3

LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during installation or relamping.
Lead the main supply cable through the cable entry of the luminaire base.
Fix the luminaire base with enclosed or any other suitable fixing material onto the mounting surface.
Be sure to use the gasket rings supplied.
Establish an earth conductor connection and make the electrical connection to the terminals.

Advice:

The expansion of glass and metal is different.
The glass must be allowed to expand.
Place glass into the luminaire base and fix the set screws hand-tight.
After tightening the set screws loosen them for half a turn to allow the glass to move.

BEGA-50264.1-LED-Wall-Luminaire-for-Indoor-Use-fig-1

Clean the luminaire regularly with solvent-free cleansers from dirt.

The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by a qualified electrician or a comparably qualified person using standard tools.
Disconnect the electrical installation.
Open the luminaire.
Please follow the installation instructions for the LED module.
Close the luminaire.