RUNHOOD Portable Power Station Instruction Manual

RUNHOOD Portable Power Station

WARNING

1. Single module DOES NOT have any function unless combined with necessary modules.
2. Clean outlets and surfaces to avoid abrasion, energy loss and charging failures.
3. Only use RUN HOOD batteries with this product. RUN HOOD takes no responsibility for any damage caused by non- RUN HOOD Power Station batteries.
4. Children and those with impairments should operate the device with assistance.
5. Don’t use the product in a strong electrostatic or electromagnetic environment which may cause the battery control board to malfunction and cause serious hazard during use.
6. DO NOT insert pins, wires, or other metals into the device case, outlets, or controls. Doing this may short circuit the product.
7. DO NOT puncture or incinerate the product or the accessories.
8. Keep RUN HOOD Power Station dry and do not expose to high heat or water.
9. The discharging temperature of Energy Bar 324 is -68~113°F/-20~45°C, while the charging temperature is 32~104°F/0~40°C.
10. When charging, DO NOT remove the EB324 from HE600-U.
11. When recharging with adaptor and USB-C simonteniously, please do not charge any other appliances at the same time.
12. Charge the battery to a minimum of 60% of its full capacity before storing it. It is recommended to charge and discharge once every three months.
13. DO NOT place heavy objects on the device.
14. Recycle and dispose of RUN HOOD Power Station in accordance with the local regulations.
15. If the product is submerged in water during use, remove the product immediately and leave it in a safe and open area. The battery should not be used again under any circumstance.
16.  If the product catches fire, it is recommended to use fire extinguishing equipment in the following order: water, sand, fire blanket, dry powder, carbon dioxide fire extinguisher.
17. When recharged through the car, please keep car’s engine working or make sure there is enough power left for the car’s battery.
18. Please go to RUN HOOD’S USER MANUAL for more information.

MODULES

ACCESSORIES

DIY COMBINATIONS

• This combination (HE600-U • 1 + EB324 • 2) is with design of swappable battery providing virtually unlimited durability. With an extra pair of EB324s, it can easily reach the capacity of 1296Wh.
• This combination (AE80-U• 1 + EB324 • 1) provides an AC output of BOW ( 230V,50Hz ), which can provide AC power to any appliances with rated power of BOW or less.
• This combination (UE256 • 1 + EB324 • 1) is with 2 outputs (USB­C, PD 100W) and 2 outputs (USB-A, QC3.0 28W), which has a maximum total power output of 256W. It can charge smart phones, laptops, tablets and other devices that can be recharged through the USB port.

RECHARGE METHODS

IMPORTANT NOTICE: The rechargeable module is EB324. Other modules are only application interfaces, but not a storage of energy. There are two ways to recharge the EB324: one with HE600-Uand the other with the UE256. You need to combine the EB324 with HE600 or UE256 for recharging the EB324. We highly recommend recharging your EB324 in pairs.

1. Insert two EB324s into HE600-U

2. Connect the Adapter/Car Charger/Solar Panel to the DC input on HE600-U.

3. FAST RECHARGE: USB-C PD 100W input can work simultaneously with DC input to recharge the EB324 faster. When recharging with adaptor and USB-C simonteniously, please do not charge any other appliances at the same time.

4. When charging, DO NOT remove the EB324 from HE600-U

5. The AC and DC output can work normally when only using one input for recharging. DO NOT using any AC or DC output when FAST RECHARGING.

6. Connect EB324 with UE256.

7. Connect the recharge cable to the USB-C PD 100W IN/OUT port to recharge.

8. When charging, DO NOT remove the EB324 from UE256.

9. The USB-C recharge cable and adapter is not included in our product range. Users can purchase the cable and adapter at their own preference from the market.

1. The DC input of HE600-Ucan reach 200W max. You can use a maximum of two RUN HOOD Solar Panels to recharge.
2. Use the DC Y cable to connect two solar panels in a parallel connection.
3. To recharge with HE600-Uand UE256, please refer to the recharge methods instruction in RUNHOOD’s USER MANUAL

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>