BEGA 51148.4 Wall Luminaire Instruction Manual

Table of Contents

BEGA-51148-4-Wall-Luminaire-product

Product Description: Wall luminaire STUDIO LINE Satin black finish Aluminum housing shield, Finish Colour velvet black
Inside hue: matt brass
Light-diffusing synthetic disks with optical structure
LED power supply unit: 220-240 V x 0/50-60 Hz DC 176-275 V
Weight: 1.6 kg
This product contains light sources of energy efficiency class(es) D

Disconnect the earth conductor terminal from the protective ground connection.
Secure the main supply cable to the cable entry on the mounting plate using the provided or suitable fastening material.
Position the mounting plate with the arrow pointing downwards.
Make electrical connections to the terminals, ensuring correct wiring. Connect the phase to the brown wire (L) and the neutral wire to the blue wire (N). Use the two loose terminals marked with DA, DA for digital control.

BEGA-51148-4-Wall-Luminaire-fig-1

Application

Wall luminaire · indoor luminaire with velvet black luminaire housing and inside hue.
The light emits upwards and downwards.
Luminaire slope angle: 18°.

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation.
If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Overvoltage protection

The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.

Lamp

51 148.4 K3

LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during installation or relamping.
Undo the hexagon socket head screw (wrench size 2.5 mm) and lift luminaire.
Unplug the earth conductor connection (plug contact).
Pass the power connecting cable through the cable entry in the mounting plate.
Fasten the mounting plate with the supplied fastening material or other suitable fastening material to the installation surface.
Note position of application of the mounting plate “arrow down”.
Establish the earth conductor connection on the earthing screw ( ) of the mounting plate.
Push silicone sleeves over the lines.
Make the electrical connection to the terminals.
Observe the correct configuration of the connecting cable. Connect the live conductor to the brown wire (L) and the neutral conductor to the blue wire (N).
The two connecting terminals marked DA, DA are provided for digital control purposes.
If these terminals are not assigned, the luminaire will work with full light output.
Make earth conductor connection between luminaire housing and mounting plate (plug contact).
Place connecting terminals inside the luminaire wall bracket.
Install luminaire over mounting plate and tighten hexagon socket head screw (wrench size 2.5 mm) evenly.
Guide the housing shield provided over the luminaire’s light-diffusing synthetic lenses and into its end position.

Cleaning · Maintenance

The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by qualified persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Defective luminaire cover must be replaced.
Close the luminaire.

Spares