MINKA LAVERY 7998-66 Gloucester 4-Light Black Outdoor Pendant Light Instruction Manual
- June 12, 2024
- MINKA LAVERY
Table of Contents
MINKA LAVERY 7998-66 Gloucester 4-Light Black Outdoor Pendant Light
Product Information
This user manual provides installation instructions for Model # 7998-66/7999-66. The product is a fixture that requires electrical wiring and is designed to be installed in an outlet box.
INSTALLATION INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
PREPARING FOR INSTALLATION (Fig. 1)
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to misplace any small parts necessary for installation.
-
Install all thread (G) into crossbar (E) and secure with hex nut (C) and washer (D). Note: The length of all thread (G) into the crossbar (E) may be adjusted if necessary. Attach crossbar (E) (part #: A-012) to outlet box (A) (not included) with outlet box screws (F) (size:8-32*1/2L). Note: the side of the crossbar (E) marked “GND” must face out.
-
Attach canopy loop (I) to all thread (G).
-
Remove screws (Q), separate cover (O) from fixture body (T), and install glass panels (P) into holder of fixture body (T) and secure with tabs (S) on top and bottom.
-
Install (4) four candelabra base bulbs (R) up to 60 watts or CFL or LED equivalent (not included) in accordance with the fixture specification. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) (NE PAS DE PASSER LA
PUISSANCE NOMINALE MAXIMALE!) -
Place cover (O) onto fixture body (T) and secure with screws (Q).
-
Adjust chain (L) to desired length by removing unneeded links. Attach one quick link (M) to end of chain (L) and then to fixture loop (N). Pass lock collar (J) followed by canopy (H) over chain and allow them to rest carefully on fixture loop (N). Attach another quick link (K) to other end of chain and then to canopy loop (I).
-
Carefully pass fixture wires through chain (L), lock collar (J), canopy (H), canopy loop (I) and all thread (G).
CONNECTING THE WIRES (Fig. 2)
-
Connect the electrical wires as shown in Fig.2. Making sure that all wire connectors (B) are secured. If your outlet box (A) has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to cross bar (E) using the green screw provided.
FINISHING THE INSTALLATION (Fig.1) -
Slide canopy (H) over canopy loop (I) and secure with lock collar (J).
Your installation is now complete. Return power to the outlet box and test the fixture.
Notice: It is important to use proper chain pliers(not included) To OPEN and CLOSE the chain included with this fixture. Do not open them with other tools that may twist or stress the chain links. It is important to use proper chain pliers like the ones shown in the diagram.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>