MINKA LAVERY 2735-709 Lavery and Reg Instruction Manual
- October 30, 2023
- MINKA LAVERY
Table of Contents
INSTALLATION INSTRUCTIONS
For item#2735-709(New. 2022/07/01)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
PREPARING FOR INSTALLATION (Fig. 1)
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
-
Thread all thread (E) into crossbar (C). Note: The length of all thread (E) into crossbar (C) may be adjusted if necessary.
-
Use lock washer (B) and hex nut (A) to secure all thread (E) to crossbar (C).
-
Take this crossbar (C) assembly and mount it to outlet box（not included）with mounting screws (D) (Size: #8-32N*L0.5”). The side of crossbar marked with “GND” must face out.
-
Connect threading nuts (H) at the end of cable into coupling (I) on fixture body.
-
Connect the electrical wires as shown in figure 2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the crossbar (C) using the green screw provided.
-
Tuck wire connectors neatly into outlet box.
COMPLETING THE INSTALLATION (Fig. 1) -
Slide canopy (F) over all thread (E) and secure using finial (G).
-
Slide glass shade (K) over socket (J) and secure with metal ring (L).
-
Install (3) three candelabra base bulbs (M) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification— DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the outlet box and test the
fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased.
LA-3573E
Documents / Resources
|
MINKA LAVERY 2735-709 Lavery and
Reg
[pdf] Instruction Manual
2735-709, 2735-709 Lavery and Reg, 2735-709 Lavery, 2735-709 Reg, Lavery and
Reg, Lavery, Reg
---|---