MINKA LAVERY 2899-691 Nine Light Chandelier Instruction Manual
- October 30, 2023
- MINKA LAVERY
Table of Contents
2899-691 Nine Light Chandelier
INSTALLATION INSTRUCTIONS
Item#2899-691 (New. 2021/08/18)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K
E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
-
Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware. -
Carefully unpack your new fixture and lay out all the parts
in a clean area. Take care not to misplace any small parts
necessary for installation. -
Determine the desired hanging height and thread rods (F1,
F2 and F3) to all thread (J) on top of fixture body. Attach
canopy (D) by threading onto rod (F1). Carefully feed wires
through each rod as you assemble. Note: Remove all
thread, if installing with one 6” rod only. -
Attach mounting plate (A) to the junction box (Not included)
with mounting screws (B) (Size: #8-32N*L0.5”). The side of
the mounting plate (A) marked “GND” and two convex
points must face out. -
The support cable is provided to support weight of fixture
while wiring. Align the fixture to mounting plate (A) and
attach hook (P) on the end of support cable (C) to a slot
located on mounting plate (A). Carefully allow the support
cable (C) to support weight of the fixture while wiring.
CONNECTING THE WIRES (Fig. 2) -
Connect the electrical wires as shown in fig 2, making sure
that all wire connectors are secured. If your junction box
has a ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the fixture’s
ground wire directly to the mounting plate (A) using the
green screw provided. -
Tuck wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1) -
Slide canopy (D) over mounting plate (A) and secure with
screws (E). -
Install (9) nine candelabra base bulbs (H) up to 60 watts
each or CFL or LED equivalent (not included) in
accordance with the fixture specification—DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!). -
Screw glass shades (I) onto socket cups (G).
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation
purposes only. It may or may not be identical to the
fixture purchased.
LA-3464E
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>