Electrolux ECF9214X Cooker Hood User Manual

October 30, 2023
Electrolux

Electrolux ECF9214X Cooker Hood

Electrolux ECF9214X Cooker Hood

Warning

  • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

  • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

  • There is a fire risk if cleaning is not carried out in accordance with the instructions;
    CAUTION: Accessible parts may become hot when used with cooking appliances.
    the air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels regulations concerning the discharge of air have to be fulfilled.
    Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
    In certain circumstances electrical appliances may be a danger hazard.

  • Do not check the status of the filters while the cooker hood is operating.

  • Do not touch the light bulbs after appliance use.

  • Do not disconnect the appliance with wet hands.

  • Avoid free flame, as it is damaging for the filters and a fire hazard.

  • Constantly check food frying to avoid that the overheated oil may become a fire hazard.

  • Disconnect the electrical plug prior to any maintenance.

  • Children don’t recognize the risks of electrical appliances. Therefore use or keep the appliance only under supervision of adults and out of the reach from children.

  • Don’t use this product outdoor.

  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

  • There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels.

  • There is a fire risk if cleaning is not carried out in accordance with instructions.

  • Do not flam under the range hood.

  • The discharge air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels.

DESCRIPTION

DESCRIPTION

Ref Q’ty Components
1 1 Air outlet base Ass
2 1 Hood body Ass
3 1 Wind housingAss
4 1 LED lamp
5 1 Transparent lamp board
6 2 Charcoal filter
7 2 or 3 2 Alu filters for 60cm model 3 Alu filters for 90cm model

Dimension(mm)

The hood may be installed in the filtering or the ducting version.

Filtering version (Fig.1 ): The hood aspirates the kitchen air saturated with fumes and odour. Purifies it through the grease filters and charcoal filters and returns clean air into the room. For constant efficiency, the carbon filters must be replaced periodically.

Ducting version (Fig.2): The hood aspirates the kitchen air saturated with fumes and odour, passes it through the grease filters and expels it to the outside through an outlet pipe. With this version the carbon filters are not required.
Decide from the outset on the type of installation (filtering or ducting). For greater efficiency, we recommend you install the hood in the ducting version (if possible}.

INSTALLATION

Before beginning installation, to remove the metal filter/s (Fig.3), in line with the handle, push the stop inwards and pull the filter down.

Before fixing, the outlet pipe for air evacuation to the outside must be installed. Use an outlet pope with: – minimum indispensable length; -Minimum possible bends (maximum angle of bend:90°); -certified material (according to the state);_ an as smooth as possible inside. It is also advisable to avoid any drastic changes in pipe cross-section (recommended diameter: 125mm).

Drill the hole in the wall for the air outlet (133 mm diameter) referring to Fig.? where the measurements for the various possibilities are indicated.
Prepare a suitable power supply. For the electrical connection, follow the instructions on the page 6 ..
Proceed with fixing the hood: Based on your requirements, you can fit the hood on the wall or on a wall unit of your kitchen. IMPORTANT: Respect the distance between the hob and lower part of the hood which must be at least 650 cm.

INSTALLATION IN DUCTING VERSION:

Make sure the air outlet A is opening(Fig 4 ).

  • CHECK THAT THE DUCTING LEVER IS IN THE RIGHT POSITION.: The lever is found on the motor unit and must be positioned no the symbol (P) in the case of installation in ducting version (Fig. 5 ).

  • Also remember that the use of charcoal filters is not necessary with the ducting version; if these are fitted, remove them(Fig. 6 ).

Fixing to the wall

Drill a hole of 133 mm diameter in the wall unit (Fig.7).
check the position of the power outlet and consider where the power cable will run, since a hole might have to be made in the wall unit to accommodate it. Draw a line on the wall in vertical line with your hob. Mark the 4 holes to be drilled in the wall, respecting the distances indicated in Fig.7; Make the 4 holes and fit the 4 screw anchors provided. Take 2 of the screws provided (Fig. 9 G) and insert them in the 2 screw anchors without screwing them down completely. Hang the hood on the 2 screws; Working form inside the hood, tighten the 2 screws completely. Now proceed with final fixing by fitting the other 2 screws H (Fig.1O ). Connect a flexible tube to the hood outlet adapter. Make the electrical connection.
INSTALLATION

Fitting under wall unit:

Before fixing the hood to the unit, drill a hole of about 133mm diameter in the wall unit (Fig.a). In any case, check the position of the power outlet and consider where the power cable will run. Drill 4 holes in the wall unit, respecting the distance indicate in Fig.a. Push the hood up against the wall unit and insert the 4 screws operating from inside the wall unit. Connect a flexible tube to the hood outlet adapter. Make the  electrical connection.
INSTALLATION

Electrical connection:

Electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards. Turn off electrical power at service entrance before wiring.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Do not use the plug and an extension cord other than the ones initially supplied with the hood.
The earthing of this hood is compulsory. Do not remove ground prong of the plug.

OPERATION

Depending on the model, the unit is equipped with the following controls:
Controls as : A= Light switch; B = Fan speed I; C = Fan speed II; D = Fan speed Ill; E = On/off.

LED LAMPS

This range hood require LED lamps
***** Max wattage : 2W
Voltage range: 220-240V
Dimensions: diameter 98mm

WARNING: Always switch off the electrical supply before carrying out any operation on the appliance. This LED lamp should be replaced with qualified person.
To change bulbs:

  1. Remove the lamp cover;
  2. Kick off the normal bulbs by hand.
  3. Replace with 2W Max LED lamp. Do not touch replacement bulb with bare hands.

MAINTENANCE AND CLEANING

SymbolWARNING!

Switch off or unplug the appliance from the main supply before carrying out any maintenance work.

Aluminum type metal filter

They are metal grid filters (as shown in Fig.3): the filters must be periodically cleaned, depending on extent of operation ( at least every four weeks). Wash the filter with neutral detergent. To remove the filters, first of all push  down the filters.

Charcoal filter

The carbon filters must be periodically replaced depending on extent of operation-on average every 6 months. To remove the carbon filters,  proceed as follows

Dishwasher

Place grease filter in the dishwasher. Select the intensive wash program with min. 65°C temperature. Put back the grease filters when they are completely dry. There might be discolouration of the grease filters after washing in dishwasher. This is normal and does not affect the performance of the grease filters.

www.electrolux.com

The Thoughtful Design Innovator.

Do you remember the last time you opened a gift that made you say, “Oh! How did you know? That’s exactly what I wanted!” That’s the kind of feeling that we at Electrolux seek to evoke in everyone who chooses or uses one of our products. We devote time, knowledge, and a great deal of thought to anticipating and creating the kind of appliances that our customers really need and want.

This kind of thoughtful care means innovating with insight. Not design for design’s sake, but design for the user’s sake. For us, thoughtful design means making appliances easier to use and tasks more enjoyable to perform, freeing our customers to experience the ultimate 21st century luxury: ease of mind. Our aim is to make this ease of mind more available to more people in more parts of their everyday lives, all over the world.

The “Thinking of you” promise from Electrolux goes beyond meeting the needs of today’s consumers. It also means we’re committed to making appliances safe for the environment-now and for future generations.

Electrolux. Thinking of you.

Share more of our thinking at www.electrolux.com

Customer Support

Indonesia
PT Electrolux Indonesia
JI. Abdul tv1uis No.3Li, Petojo Selatan,Gambir,
Jakarta Pusat 10160, Indonesia
Hotline Service: 080Li lll 9999
Stv1S: 0812 8088 8863
WA: 0811 8339 777
Email: customercare@electrolux.co.id
Website: www.electrolux.co.id
Diimpor oleh PT Electrolux Indonesia.

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals