Hukoro FAY-US-LT-113-SG Alfa 8 Light Geometric Cage Lantern Pendant Instruction Manual
- October 30, 2023
- Hukoro
Table of Contents
Hukoro FAY-US-LT-113-SG Alfa 8 Light Geometric Cage Lantern Pendant
ASSEMBLY INSTRUCTIONS
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
Ladder
|
Safety glasses
|
Electrical tape
---|---|---
Phillips screwdriver
|
Flat blade screwdriver
|
Pliers
Wire strippers
|
HARDWARE INCLUDED
Fixture
|
Iron Rack
| Ball nuts
---|---|---
Chain
|
Canopy
|
Screw Collar Ring
Mounting Unit
|
Mounting Screws
|
Wire Nuts
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
INSTALLATION
STEP 1
-
Installation fixture.
-
Attach the iron rack onto fixture using ball nuts.
STEP 2
- Choose the length of the chain you need (Open the chain using a phillips screwdriver (not included) and pliers (not included)).
- Attach the end of the chain to the loop on the fixture.
STEP 3
Use the mounting screws to attach the mounting unit to the junction box (not included).
STEP 4
- Pass the chain and the branch wires through the screw collar ring and canopy.
- Attach the end of the chain to the mounting unit.
- Feed the branch wires through the pipe nipple on the mounting unit.
STEP 5
Make the electrical connection from the junction box (not included) to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Next, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.
STEP 6
Secure the canopy to the mounting unit with the screw collar ring.
STEP 7
Install bulbs (not included)
CUSTOMER SUPPORT
If you need further assistance, please contact us by Email: customersupport@superiordecorinc.com