KSR LIGHTING KSRSF336 Multi Wattage Triple CCT Bulkhead Installation Guide
- June 3, 2024
- KSR LIGHTING
Table of Contents
KSR LIGHTING KSRSF336 Multi Wattage Triple CCT Bulkhead
Important Information
It is recommended that these luminaires are installed and fitted by a
qualified electrician ensuring the installation complies with current IEE
wiring regulations & local building control. These products are designed for
connection to a 240V~50Hz supply. Any faulty, broken or damaged luminaires
should be replaced immediately. KSR will not accept responsibility for any
claims arising from a poor installation.
Please Note: The limited warranty shall be deemed null and void in the
following circumstances: Failure by the installer, end user or any third party
to exercise caution to protect any covered product or part from outside
damage, adverse temperature (normal operating ambient temperature -15°C –
+30°C), humidity conditions, fluctuations in the electrical system or physical
abuse as well as failure related to workmanship in the installation of the
products or parts.
Important User Advice
Always switch off mains supply before servicing. Do not use Megger or similar high voltage instruments. Due to the fact this luminaire contains electronic components that maybe damaged by high test voltages, they must be disconnected from the circuit before testing. To prevent damage to the driver, do not mix with conventional magnetic ballasts on the same electrical circuit. At the end of life the luminaire is classed as WEEE under directive 2014/30/EU and should be disposed of in accordance with local legislation.
Installation Procedure
- Isolate mains supply before installation.
- Unscrew and retain the four screws and remove the diffuser.
- Loosen the single LED tray screw as indicated in Fig.2 and lift the hinged tray to gain access to the wiring terminals.
- Pass intended supply wires through grommet.
- Ensure the fixing surface is flat and even.
- Fix base to the wall, ceiling or besa box using adequate fixings with regard to the type of surface.
- Ensure incoming cables are protected.
- Terminate wiring as per Fig. 3, please note an Earth terminal is only supplied to aid the continuation of the Earthcircuit.
- Please ensure battery is connected, this battery compartment can be accessed as shown overleaf.
- Select LED colour and wattage required using the switches on the LED driver Note: Never change the LED colour
- or wattage with the luminaire powered on as this can damage the luminaire. Fig. 4.
- To set Photocell adjust the Lux level required via the adjuster (anti-clockwise = lowest, clockwise = highest)
- and to test simply cover photocell when powered on in daylight and wait for the luminaire to Light up.
- Proceed to Re-secure the LED tray.
- Make sure the seal is in place in the diffuser and undamaged.
- Replace the diffuser re-secure using the four retained screws.
- Turn on the mains supply and test luminaire. If using an optional rim clip the rim over the fitting.
DIMENSION
Instruction when using Photocell with Optional Rim
PLEASE NOTE: If using an optional rim to ensure the photocell is not obscured from ambient light. Measure 18mm from the back of the rim and slowly drill a 10mm hole using a brad point drill bit. Install rim to line up the hole with the sensor. Turn on the mains supply and test luminaire.
Lamp Details
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>