CANARM IOL599 Wall Light Penn 1 Light 10.38 Inch Instruction Manual

Table of Contents

Safety Precautions

Turn off the electrical power before starting the installation of the light fixture.
Ensure wiring supplies as required by local electrical code.
The product must be installed by a person familiar with the construction and operation of the product.
To clean the fixture, turn off the power, wait for it to cool, and wipe with a clean, soft cloth.

Installation Steps

INSTRUCTIONS ABOUT RISK OF FIRE OR INJURY TO PERSONS READ ALL INSTRUCTIONS

SAVE THESE INSTRUCTIONS

TURN OFF THE ELECTRICAL POWER BEFORE STARTING THE INSTALLATION OF THE LIGHT FIXTURE.
WIRING SUPPLIES AS REQUIRED BY LOCAL ELECTRICAL CODE.
THIS PRODUCT MUST BE INSTALLED BY THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures

Attach nipple to the mounting bracket. Adjust so it will clear the hole in the back of the fixture and then lock the nipple in place with hexnut. Attach the mounting bracket to the electrical box with electrical box screws (not included).
Option 1: Connect (push) electrical wires from the electric box (house wiring) into the correct inserts.
Option 2: For multiple green (ground), black (live), and white (neutral) wires joined in the electrical box (house wiring), attach a single “green”, “black” and “white” jumper wire before connecting. Strip 7mm from a 6 in. jumper wires supplied. Then connect (push) wires into the correct inserts . Connect (push) electrical wires from the fixture into the correct inserts.
Once connections of wires are completed, carefully tuck wires and wire nuts into the electrical box making sure bare wire (on the black and white) is visible at the wire nuts. Position the hole in the fixture over the nipple and secure it in place with a star washer and cap nut.
Install proper bulb type and wattage (not included).
After installation, seal around the top and side perimeter between the fixture and the wall surface with weather-resistant caulk. The bottom should be left un-caulked to prevent moisture build-up. Apply a small amount of weather-resistant caulk around the side perimeter between the cap nut and the mounting plate.

NEED HELP?
Call or Email us first

Our service team is ready to answer your questions…
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday – Friday
8 AM – 5 PM E.S.T.

Q: Do I need to use specific bulbs for this fixture?
- A: Yes, ensure to installation of proper bulb type and wattage as recommended (not included).
Q: What if I have multiple ground, live, and neutral wires in my electrical box?
- A: In that case, attach a single jumper wire before connecting and ensure the correct insertion of wires into the fixture.
Q: How should I seal the fixture after installation?
- A: Seal around the top and side perimeter with weather-resistant caulk, leaving the bottom un-caulked to prevent moisture build-up.