TRUE FINE TD90036C, TD90032C 4-Light Chandelier Instruction Manual
- October 30, 2023
- TRUE FINE
Table of Contents
4-Light Chandelier
Instruction Manual
Overview
Assembly Instruction
- Screw Stem (C) onto the Fixture body (A), install Iron sleeve (B) to the lamp holder.
- Thread the wires through the hole in the top of Shade (D), then screw Loop (E) to Stem (C).
- Fix Mounting strap (I) to outlet box with Screw (J).
- Thread the wires through Canopy (H) and Mounting strap (I), link Loop (E) and Mounting strap (I) by Fixture chain (F).
- Connect the wires according to the picture above. (Please refer to the wiring instruction for details )
- Fix Canopy (H) to Mounting strap (I) with Canopy lock ring (G).
Wiring Instruction
-
Insert the green grounding screw into the hole with two raised dimples on the mounting bar. Wrap the ground wire from the fixture (if supplied) around the green grounding screw, then connect it to ground wire from the outlet box (if not fixed on the outlet box) using a wire connector(not supplied). If ground wire from the fixture is not supplied, wrap the ground wire (if not fixed on the outlet box) from the outlet box around the green grounding screw and tighten it.
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES. -
Take note of the color of the wire(s) on your fixture. Identify which group your fixture wire(s) falls into and connect the wires according to the directions below:
[GROUP A]:
Connect to Black House Wire| [GROUP B]:
Connect to White House Wire
---|---
BLACK| WHITE
PARALLEL WIRE (round & smooth)| PARALLEL WIRE (square & ridged)
WHITE OR GREY WITH TRACER| WHITE OR GREY WITHOUT TRACER
BROWN, GOLD OR BLACK WITHOUT TRACER| BROWN, GOLD OR BLACK WITH TRACER -
Take your fixture wire(s) from [Group A] and place evenly against the black wire from the outlet box. Do NOT twist wires together before using wire connectors.
-
Fit a wire connector over the wires and screw the connector clockwise until you feel firmness.
-
Try gently to pull the connector off the wires. If you can pull the connector off, carefully re-do steps 3 and 4 as above, and check again for a firm connection.
-
Connect the fixture wire from [Group B] to the white wire from the outlet box in the same manner. Make sure no bare wires can be seen outside wire connectors.
Product Specifications
Input voltage 120V
Rated power 40 MAX × 4
Lamp socket E12
Product Packaging
Fixture body × 1
Mounting strap × 1 & Canopy × 1
Shade × 1 & Loop × 1
Screw × 2 & Wire nut × 3
Iron sleeve × 4
Lamp instruction × 1
Cleaning
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
Safety Information
Always switch off the electricity supply and allow to cool for 10 minutes
before changing the light bulbs.
CONTACT US
E-mail: service@24h-reply.com
Print in china
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>