Executive Wood Products CLR 235-S Counselor Swivel Wood Lectern Instruction Manual
- June 1, 2024
- Executive Wood Products
Table of Contents
Executive Wood Products CLR 235-S Counselor Swivel Wood Lectern
Congratulations
Congratulations, your Counselor Swivel™ is the perfect blend of traditional lines, hardwood construction, old world quality, and cutting-edge innovations. It is comprised of:
Feature
- Solid hardwood and hardwood solids
- Swivel base, with a ball bearing swivel mechanism and swivel capability 45 degrees to the left and right of center
- PVC electrical conduit for wire management from top to bottom, 1 ½” inside diameter
- Drop Top for flat laptop surface or angled speaking surface
- Rear wheels for ease of movement
- Easy assembly, tools included
Assembly Instructions
Step 1:
Unpack both boxes and lay out the parts as pictured:
Figure A Hardware and Tools:
6- 5/16” x 1 ¼” hex head bolts (requires ½” wrench for assembly)
6- 5/16” flat washers
3- ¼” x 1 ½” T-Bolts (hand tighten)
1- Flat blade Screwdriver (if needed to remove locator pins as described
below)
1- ½” wrench (to attach pedestal to base as described below)
Figure B Base section with removable locator pins, B-1 installed
Figure T Top Section
Figure P Pedestal (Center Section)
Step 2:
Place Base, Figure B, wheels side down (the wheels are located at the rear of
the base)
Note: threaded locator pins, B-1, protrude from the swivel bearing
mechanism
Step 3:
Lift Pedestal, Figure P, (opening is at the rear of pedestal) and lower down
on top of base, protruding PVC pipe should slide into curved slot and two
locator pins will slide through corresponding holes in Pedestal
Step 4:
Insert four 5/16” X 1 ¼” hex head bolts, with 5/16” washers, through four
holes in base, exclusive of two locator pins
Tighten bolts clockwise, until all four are snug
Remove two locator pins, turn clockwise and use flat blade screwdriver if
necessary. Each pin has a screwdriver slot on top
Insert two remaining bolts and washers into locator pin holes and snug Tighten
all six bolts using the included ½” inch wrench, do not overtighten
Step 5:
Position Top Section, Figure T, on top of Pedestal and align three fastening
holes between the two parts (In the top, fastening holes are those with
threaded inserts)
From inside the cabinet insert the three T-Bolts up through the Pedestal top
and into the threaded inserts in the bottom of the Top Section, securely hand
tighten
When moving your lectern, grasp the top with both hands and tilt back approximately 45 degrees until lectern rolls freely on its wheels.
Customer Support
Questions, call Executive Wood Products 573-468-3047
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>