Hukoro F42153 24 Inch 3 Light Vanity Light Instruction Manual
- October 30, 2023
- Hukoro
Table of Contents
Hukoro F42153 24 Inch 3 Light Vanity Light
Product Information
The product is a light fixture that comes with hardware and tools required for installation. The hardware included in the package consists of a fixture, glass shade, ball nuts, mounting unit, wood screws, wall anchors, mounting screws, and wire nuts. The product also comes with an exploded parts diagram to assist with the installation process. The product requires an electrical connection to function and bulbs are not included.
ASSEMBLY INSTRUCTIONS
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or b removing the fuse at the fuse box.
CAUTION
If you need further assistance, please contact us by Email:
[email protected]
EXPLODED PARTS
Product Usage Instructions
- Before starting the installation process, ensure that the power supply to the junction box is turned off.
- Unscrew the ball nuts and green grounding screw from the mounting unit.
- Attach the mounting unit to the junction box (not included) using the mounting screws. Secure the mounting unit to the ceiling with wood screws and wall anchors.
- Make the electrical connection from the junction box (not included) to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative, and ground wires with the supplied wire nuts. Secure with electrical tape.
- The black or red wire (hot) from the junction box should be connected to the smooth side of the wire from the fixture identified with the label L.
- The white wire (neutral) from the junction box should be connected to the ribbed side of the wire from the fixture identified with the label N.
- The bare or green ground wire from the junction box should be connected to the ground wire from the fixture using a wire nut.
- Secure the fixture to the mounting unit with the ball nuts.
- Remove the socket rings from the socket. Attach the glass shade onto the fixture using socket rings.
- Install the bulb (not included).
- Turn on the power supply to the junction box and test the product to ensure it is functioning correctly.
If you require further assistance with the installation process, please contact the manufacturer’s customer support team via email at [email protected].
TOOLS REQUIRED
HARDWARE INCLUDED
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
Read User Manual Online (PDF format)
Loading......