Hukoro F46814-QC 4 Light Dimmable Vanity Light Instruction Manual

Hukoro F46814-QC 4 Light Dimmable Vanity Light

Product Information

The product is a light fixture that comes with hardware and parts required for assembly and installation. The product includes a fixture, glass shade, mounting unit, ball nuts, mounting screws, wire nuts, and other tools required for installation such as a ladder, safety glasses, electrical Phillips screwdriver, flat blade screwdriver, pliers, and wire strippers. The product may have slight differences in parts shown per light fixture.

Product Usage Instructions

1. Before assembly and installation, ensure that the power supply to the junction box is turned off. Remove the fuse at the fuse box to ensure that there is no electricity flowing through the wires.
2. Unscrew the ball nuts from the mounting unit and use the mounting screws to attach the mounting unit to the junction box.
3. Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative, and ground wires with the supplied wire nuts. Secure with electrical tape.
4. Attach the fixture to the mounting unit through screw holes as shown and secure it with ball nuts.
5. Remove the socket ring from the socket. Attach the shade onto the fixture using socket ring.
6. Install bulbs (not included).

Note : Sealing tape is not included in the product but it is recommended to use sealing tape during installation for added safety.
By following these instructions, you can safely assemble andinstall the light fixture for usage.

ASSEMBLY INSTRUCTIONS

CAUTION

• Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
• Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box

TOOLS REQUIRED

HARDWARE INCLUDED

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

EXPLODED PARTS

INSTALLATION

STEP 1

• Unscrew the ball nuts from the mounting unit.
• Use the mounting screws to attach the mounting unit to the junction box.

STEP 3

• Make the electrical connection from the junction box to the fixture.
• Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.

STEP 4
Attach the fixture to the mounting unit through screw holes as shown, and secure it with ball nuts

STEP 5

• Remove the socket ring from the socket.
• Attach the Shade onto fixture using socket ring..

STEP 6

• Install bulbs (not included).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>