Hukoro F30-050959-02h Alfa 9-Light Modern Rectangle Lantern Pendant Light Instruction Manual
- October 30, 2023
- Hukoro
Table of Contents
F30-050959-02h Alfa 9-Light Modern
Rectangle Lantern Pendant Light
Instruction Manual
ASSEMBLY INSTRUCTIONS
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
HARDWARE INCLUDED
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
INSTALLATION
STEP 1
Unscrew the ball nuts A from the mounting unit.
Use the mounting screws to attach the mounting unit to the junction
box.
STEP 2
Attach the iron rack B onto bracket A using screws.
STEP
3
Attach the bracket B onto iron rack B using ball nut B.
STEP 4
Attach the fixture onto bracket B as shown.
STEP 5
Screw the stem E into the fixture
STEP 6
Attach the bracket B into the iron rack B and fixture as shown.
STEP 7
Adjust arms to proper position. STEP 8
Attach the iron rack A onto the iron rack B and bracket B using ball nuts B as
shown. STEP 9
Place the cover onto the iron rack A, then secure with decorative nut. STEP
10
Install stem connecting the upper and lower ends of the lamp body.
Install stems (A~D) based on the desired length of the item on the fixture,
adding conopy one finished.
STEP 11
Make the electrical connection from the junction box to the fixture.
Connect the ground wire to the mounting unit using the preinstalled green
ground screw. Then, connect the positive, negative and ground wires with the
supplied wire nuts. Secure with electrical tape.
STEP 12
Secure the canopy to the mounting unit with the ball nuts A.
STEP 13
Install bulb (not included)