PPI ISOSIG-35S Programmable 4-Wire Isolated Signal Converter User Manual
- June 11, 2024
- PPI
Table of Contents
PPI ISOSIG-35S Programmable 4-Wire Isolated Signal Converter
CONNECTION DIAGRAM
DIMENSIONS (mm)
INPUT WIRING DIAGRAM
DC linear (mA / mV / V)
Connect Signal Positive to terminal marked (+) & Negative to terminal marked
(-) as shown in Figure 1.
Thermocouple
Connect Thermocouple Positive to terminal marked (+) & Negative to terminal
marked (-) as shown in Figure 2 .
RTD Pt100, 3-Wire / 2-Wire
For 3-Wire configuration, connect single leaded end of RTD bulb to terminal 4
and the double leaded ends to terminal 5 and 6 (interchangeable) as shown in
Figure 3. For 2-Wire configuration, connect RTD bulb across terminals 4 & 5
(interchangeable).
2-Wire Loop Powered Transmitter connection using Internal 24VDC
Excitation(Optional)
Power 2-wire Transmitter through terminal marked (24V EXT). Connect the Output
of 2-Wire Transmitter to Terminal marked (+). Leave terminal marked (-)
unconnected as shown in Figure 4.
OUTPUT-1 & OUTPUT-2 WIRING DIAGRAM
DC linear (mA / V)
Connect Signal Positive to terminal marked (+) & Negative to terminal marked
(-) as shown in Figure 5 & Figure 6.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>