PPI Neuro 100 Z Universal Process Indicator User Manual
- June 11, 2024
- PPI
Table of Contents
PPI Neuro 100 Z Universal Process Indicator
Product Information:
The Enhanced Range Universal Process Indicator is a device that displays the current process value of an input signal. It has a range of -19999 to +99999 and can be used with various input types such as DC Lin. Volts/Current, Kelvin, Percentage, Pascals Mpascals, and many more.
Parameters
Operator Page and Parameters
The Operator Page displays the current process value. The default settings for the alarm setpoints are Alarm-1 Setpoint, Alarm-2 Setpoint, Alarm-3 Setpoint, and Alarm-4 Setpoint. The default values for Process Low and Process High are -200.0 and 1376.0 respectively.
Alarm Parameters
The Alarm Parameters page allows the user to set up to four alarms. The user can choose the Alarm Type from None, Process Low, and Process High. The default value for Alarm Type is None. The user can also adjust the Alarm Hysteresis and Inhibit, as well as the Alarm Logic and Latch.
Retransmission Parameters
The Retransmission Parameters page allows the user to set up the Recorder Output Type, Recorder Low, and Recorder High. The default value for Recorder Output Type is 0 to 20mA. The user can also set the minimum and maximum counts for the Recorder Low and High.
Input Configuration Parameters
The Input Configuration Parameters page allows the user to set the Input Type, Resolution, Units, PV Range Low, PV Range High, Offset, and Digital Filter. The default Input Type is 0-20mA and the default Resolution is 0.1. The user can set the PV Range Low and High for DC Lin. Volts/Current, as well as the Digital Filter time.
Supervisory Parameters
The Supervisory Parameters page allows the user to adjust the Alarm SP Adjustment on Operator Page, Remote Acknowledge Switch, Recorder Baud Rate, Parity, Serial ID Number, and Serial Write Permission.
Front Panel Layout
The front panel layout includes the upper and lower readouts, Alarm Status indicators, Alarm Acknowledge Key, Page Key, Enter Key, Down Key, Up Key, and Symbol Key. These keys are used to navigate through the different pages and adjust the parameters.
Product Usage Instructions:
- Connect the input signal to the device.
- Power on the device.
- Use the Page Key to navigate to the desired parameter page.
- Use the Up and Down Keys to adjust the parameter values.
- Press Enter to confirm the parameter value.
- Repeat steps 3-5 for all desired parameters.
- Once all parameters are set, use the Symbol Key to exit set-up mode.
- The current process value will be displayed on the Operator Page.
- If an alarm is triggered, the corresponding Alarm Status indicator will light up and an audible alarm will sound. Press the Alarm Acknowledge Key to acknowledge the alarm.
ASSEMBLY
Operation Manual
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>