VELOSSA TECH 2016-2018 Camaro SS BIG MOUTH Ram Air Intake Installation Guide

July 21, 2024
VELOSSA TECH

VELOSSA TECH 2016-2018 Camaro SS BIG MOUTH Ram Air Intake

VELOSSA-TECH-2016-2018-Camaro-SS-BIG-MOUTH-Ram-Air-Intake-
PRODUCT

Product Information

Specifications:

  • Compatible Vehicles: 2017-2023 Chevrolet Camaro ZL1 and
    2016-2018 Camaro SS

  • Product Name: BIG MOUTH Ram Air Intake

  • Installation Time: Approximately 2 hours

  • Tools Required: Basic hand tools

Frequently Asked Questions

Q: How tight should I tighten the nuts during installation?

A: Snug is enough. Avoid overtightening to prevent damage.

Q: Do I need to completely remove the bumper for installation?

A: Complete bumper removal is not necessary, only the top portion for access to the cowl area.

Kit Contents

  • Please review this document before attempting installation.
  • You will need basic hand tools and about 2 hours of installation time.
  • Please review the table below and make sure you have received the kit contents.VELOSSA-TECH-2016-2018-Camaro-SS-BIG-MOUTH-Ram-Air-Intake-FIG-1

Stock Components Removal

Get access to the area shown below by removing the top screws bumper screws and wheel well screws of the bumper. Complete bumper removal is not necessary, just the top portion of the bumper to allow access to the cowl. Using a jack on the driver’s side is suggested since it helps the bumper sit lower.

VELOSSA-TECH-2016-2018-Camaro-SS-BIG-MOUTH-Ram-Air-Intake-
FIG-2

Begin by removing the 3 ribbed clips that hold this plastic piece to the radiator shroud and crash bar.

VELOSSA-TECH-2016-2018-Camaro-SS-BIG-MOUTH-Ram-Air-Intake-
FIG-3

The Big Mouth is meant to be tucked as shown below. Ensure that the cradle mounting region grips the diagonal crossbeam. Push the rightmost area up against the headlight and push down.

VELOSSA-TECH-2016-2018-Camaro-SS-BIG-MOUTH-Ram-Air-Intake-
FIG-4

Big Mouth Installation

Place the mount plate behind the crossbeam and insert the 65mm bolt through the right-side hole. Spin the nut on by hand, do not tighten yet. Insert the 100mm bolt in the passenger side hole and begin tightening both nuts in an alternating pattern, SNUG IS ENOUGH.

VELOSSA-TECH-2016-2018-Camaro-SS-BIG-MOUTH-Ram-Air-Intake-
FIG-5

Finalize

Re-install the bumper the same way it was removed and ENJOY!

VELOSSA-TECH-2016-2018-Camaro-SS-BIG-MOUTH-Ram-Air-Intake-
FIG-6

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

VELOSSA TECH User Manuals

Related Manuals