FLOWMASTER 717992 2016ͳ22 Chevrolet Camaro 3.6L Engine Instruction Manual
- June 9, 2024
- FLOWMASTER
Table of Contents
FLOWMASTER 717992 2016ͳ22 Chevrolet Camaro 3.6L Engine
OVERVIEW
1. Take a moment to read and understand these instructions before installing your Flow master performance system.
NOTE: Please inventory all parts now before continuing and if necessary, report any missing items to our tech line. This will avoid potentially stranding your vehicle until any missing replacement parts arrive.
ITM # PART # DESCRIPTION QTY.
1| 70001-587| Right Muffler Assembly| 1
2| 70001-588| Left Muffler Assembly| 1
N/A| PK822| Hardware Package includes:| 1
3| MC225BS| 21⁄4″ Stainless Band Clamp| 2
4| HW502| 7⁄15″ Hanger Keeper| 2
REMOVE STOCK EXHAUST SYSTEM
Raise vehicle up on a hoist or rack to working height. If you don’t have
access to a hoist or rack, support vehicle with jack stands.
WARNING: Avoid serious burns! Allow your vehicle time to cool completely
before touching any factory engine components.
To ease preparation and installation of your new kit:
- Apply penetrating lubricant to mounts, bolts and clamps before you remove them.
- Use stands as necessary to support parts as you detach them from your vehicle and again as you install new parts.
Mark tailpipes 11⁄2″ back from rear of suspension cross- member. Cut pipes at each mark, then deburr.
Dismount both front wire hangers, remove nuts (x4) and mu ffl er/pipe hangers (x2) from muffl er rear then disassemble and set aside mu ffl er from vehicle. Retain nuts and mu ffl er/pipe hangers for later use.
INSTALL FLOWMASTER EXHAUST SYSTEM
Remove nuts from stock and Flow master clamps, apply anti-seize compound to bolts and re-install nuts.
NOTE: The image in this step is intended for illustrative purposes only and may or may not accurately reflect components included in your kit.
Place (x2) clamps (3) onto left (2) and right (1) mufflers then connect them to exhaust and insert wire hangers (x2) into isolators. Secure muffler ends with nuts and muffler/pipe hangers (removed step 4).
- Adjust and level mufflers maintaining 1⁄2″ clearance around them, then tighten all clamps.
- Slide (x2) 1⁄16″ hanger keepers (4) onto each sideways hanger to secure exhaust system.
- Recommended: Secure slip fit connections with a 1-inch tack weld then spray high-temp paint over each weld to prevent rust and premature corrosion.
Congratulations, the installation of your FLOWMASTER performance exhaust system is now complete!
Installation Diagram
www.flowmastermufflers.com Technical Support 866-464-6553
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>