FLOWMASTER 717973 Performance Exhaust System Instruction Manual
- June 13, 2024
- FLOWMASTER
Table of Contents
Installaton Instrucons
717973
2006-08 DODGE RAM 1500
5.7L ENGINE
OVERVIEW:
- Take a moment to read and understand these instruc ons before installing your Flowmaster performance system.
NOTE: Please inventory all parts now before con nuing and if necessary, report any missing items to our tech line. This will avoid poten ally stranding your vehicle un l any missing replacement parts arrive.
| ITM # | PART # | DESCRIPTION | QTY. |
|---|---|---|---|
| 1 | 70006-591 | Muffl er Assembly | 1 |
| N/A | PK1079 | Hardware Package includes: | 1 |
| 2 | 390HA | Clamp Hanger | 1 |
REMOVE STOCK EXHAUST SYSTEM:
-
Raise vehicle up on a hoist or rack to working height. If you don’t have access to a hoist or rack, support vehicle with jack stands.
WARNING:
Avoid serious burns! Allow your vehicle me to cool completely before touching any factory engine components.
To ease prepara on and installa on of your new kit:
• Apply penetra ng lubricant to mounts, bolts and clamps before you remove them.
• Use stands as necessary to support parts as you detach them from your vehicle and again as you install new parts. -
Cut tailpipe at muffl er exit. Disassemble hanger wire from isolator and remove tailpipe sec on from vehicle.
-
Support muffl er and disassemble wire hangers from isolators. Loosen ring clamp, disconnect inlet pipe then remove exhaust system.
NOTE: Clamp connec on may need be heated or cut to be separated.
INSTALL FLOWMASTER EXHAUST SYSTEM:
-
Remove nuts from stock and Flowmaster clamps, apply an -seize compound to bolts and re-install nuts.
NOTE: The image in this step is intended for illustra ve purposes only and may or may not accurately refl ect components included in your kit. -
Place clamp hanger (2) onto inlet pipe (1) then insert (x3) hangers into isolators and connect it to exhaust pipe; lining inlet pipe notch up to front pipe tab. Tighten clamp enough to allow for adjustment.
-
Adjust muffl er then secure vent hose and brake lines away from heat. Tighten clamp fully.
-
Recommended: Secure slip-fi t connec ons with a 1-inch tack weld then spray high-temp paint over each weld to prevent rust and premature corrosion.
Congratulaons, the installa on of your FLOWMASTER performance exhaust system is now complete!
Installaton Diagram
717973
2006-08 DODGE RAM 1500
5.7L ENGINE
www.flowmastermufflers.com
Technical Support866-464-6553
717972
Rev 12/09/21
Documents / Resources
|
FLOWMASTER 717973 Performance Exhaust
System
[pdf] Instruction Manual
717973 Performance Exhaust System, 717973, Performance Exhaust System, Exhaust
System, System
---|---