CleanView/PowerEdge/PowerGlide® Pet Slim Cordless Vacuum Brush/Foot Area | Support
- June 7, 2024
- Bissell
Table of Contents
If you’re experiencing issues in the Brush/Foot area follow these steps to
resolve:
-
Turn OFF > Remove the Foot Assembly
- Press the release button at the bottom of the Extension Wand
-
Remove Access Plate by turning the 2 Screws
- Unhook the Brush from the Belt and lift Brush out > Remove all debris from Brush and Brush End Caps
-
For all 2900’s:
- Remove the Rotating Side Brushes
- There is only 1 Screw to remove the Access Plate
- Unhook the Brush from the Belt and lift Brush out > Remove all debris from Brush and Brush End Cap
-
Stand Brush upright > Hold the top and spin
- Is should spin freely, if not > Replace Brush > Go to Parts & Supplies
-
Clear all debris from the Suction Channel
- You should be able to see through the opening (where the Extension Wand attaches) into the Brush area
- If not, clear Channel of all debris
-
Inspect Belt, Brush and Brush Access Plate for damage
- If damaged > Replace the damaged part (If Belt is damaged the Foot Assembly will need to be replaced) > Go to Parts & Supplies
-
Reattach Brush into Belt > Guide Brush into place
-
Reattach Brush Access Plate > Secure 2 Screws
-
Reconnect Foot to Extension Wand then to Hand Vac
-
Has this resolved the issue?
- Yes > Great! Glad we can get you back to Cleaning
- No > please Contact Us
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>