FLOWMASTER 717974 Performance Exhaust System Instruction Manual
- June 13, 2024
- FLOWMASTER
Table of Contents
Installaon Instructons
717974
200922* RAM 1500
5.7L ENGINE*
Classic Body Only**
OVERVIEW
- Take a moment to read and understand these instructons before installing your Flowmaster performance system.
NOTE: Please inventory all parts now before connoting and if necessary, report any missing items to our tech line. This will avoid paternally stranding your vehicle unlay missing replacement parts arrive.
| ITM # | PART # | DESCRIPTION | QTY. |
|---|---|---|---|
| 1 | 70006-557 | Muffler Assembly | 1 |
| N/A | PK1052 | Hardware Package includes: | 1 |
| 2 | MC300BS | 3″ Stainless Band Clamp | 1 |
REMOVE STOCK EXHAUST SYSTEM
-
Raise vehicle up on a hoist or rack to working height. If you don’t have access to a hoist or rack, support vehicle with jack stands.
WARNING:
Avoid serious burns! Allow your vehicle me to cool completely before touching any factory engine components.
To ease preparator and installaon of your new kit:
• Apply penetrant lubricant to mounts, bolts and clamps before you remove them.
• Use stands as necessary to support parts as you detach them from your vehicle and again as you install new parts.
-
For factory single and dual tailpipe vehicles: Cut pipe(s) at muffler exit, disassemble wire hangers from isolators and remove tailpipe(s).
-
Disassemble wire hangers from isolators on muffler and inlet, then remove clamp on slipconnec on behind factory Y-pipe. Remove muffler and set aside.
NOTE: To separate clamp connexon, heat then twist it off of tab (as shown below).
INSTALL FLOWMASTER EXHAUST SYSTEM -
Remove nuts from stock and Flowmaster clamps, apply unseize compound to bolts and re-install nuts.
NOTE: The image in this step is intended for illustrate purposes only and may or may not accurately reflect components included in your kit.
-
Place clamp (2) onto muffler assembly (1) lining notch up to tab then connect it to inlet pipe and insert wire hangers into isolators then gotten clamp.
-
Recommended: Secure slip-fitconnecon with a 1-inch tack weld then spray high-temp paint over weld to prevent rust and premature corrosion.
Congratulants, the installaon of your FLOWMASTER performance exhaust system is now complete!
717974
Rev 01/17/22
www.flowmastermufflers.com
Technical Support 866-464-6553
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>