Lauben 60SB Vacuum Sealer User Manual

June 5, 2024
Lauben

Lauben 60SB Vacuum Sealer User Manual
Lauben 60SB Vacuum Sealer

TECHNICAL SPECIFICATIONS

Item No. LBNVS60SB
Rated voltage AC100–120V, AC220–240V
Rated frequency 50 Hz–60 Hz
Rated power 110 W
Sealing time 8–12 seconds
Vacuum/sealing time 10–12 seconds
Vacuum level > -60 kPa
Dimensions 402×161×83 mm (H×W×L)
Net weight 1.5 kg
Gross weight 1.9 kg

Safety Instruction – General

Please read all the instructions before using the appliance. Keep this manual for future reference

This appliance is designed only to be used in households

  • Do not allow children or unauthorized people to handle the appliance. Keep it out of their reach.

  • Pay extra attention if the appliance is used near children.

  • Do not use the appliance as a toy.

  • The packaging contains small pieces, that can be dangerous for children. Always store the product out of reach of children. The bags may cause suffocation and the parts they contain are a choking hazard.

  • Do not allow the power cord to hang freely over the edge of the countertop.

  • Do not use the appliance outdoors or on a wet surface, there is a risk of electric shock.

  • Do not use any accessories other than those recommended by the manufacturer.

  • Do not use the appliance with a damaged cord or plug. Have it repaired immediately by an authorized service center.

  • Keep the appliance away from heat sources such as radiators, ovens and other devices that produce heat and keep it out of direct sunlight.

  • Do not touch the appliance with wet hands.

  • When installing accessories, cleaning and maintaining or in the event of a malfunction, switch off the appliance and unplug it from the mains socket.

  • Do not switch on the appliance if the accessories are not properly fitted and without any food inside.

  • The appliance is only suitable for home use and is not intended for commercial use.

  •  Do not immerse the power cord, plug or appliance in water or any other liquid.

  • Check the appliance and the power cord for damage regularly. Never switch on a damaged appliance.

  • Before cleaning and after using the appliance, switch the appliance off, unplug it from the mains and  allow it to cool down.

  • Do not repair the appliance yourself. Contact an authorized service center.

  • This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge only if they are supervised or have been instructed concerning the safe use of the appliance and understand the hazards involved.
    Do not let children play with the appliance.

  • This appliance is not designed to be operated using an external timer, remote control or any other component that switches the appliance automatically because there is a risk of fire if the appliance is covered or positioned incorrectly when the appliance is put into operation.

  • Do not use the appliance in any other way than as described in this manual.

  • Remove all the packaging and marketing materials from the appliance before first use.

  • Make sure the mains voltage corresponds to the values on the rating label of the appliance.

  • Do not leave the appliance unattended when it is switched on or connected to the mains.

  • Only place the appliance on a stable and heat-resistant surface away from other heat sources.

  • Care should be taken when handling the appliance if it contains hot food or water.

  • Do not touch the hot surface. Use handles and buttons.

  • Disconnect the appliance from the mains socket if it is not being used.

  • Be careful when opening the appliance lid to avoid scalding.

  • Observe a safe distance of the appliance from flammable materials such as furniture, curtains, blankets, paper, clothing, etc.

  • When disconnecting the unit from the mains socket, never pull the power cord, hold the plug and pull it out to disconnect it.

  • Allow adequate ventilation around the appliance when it is used.

  • Do not place any objects on the appliance.

  • Do not drop the appliance or subject it to severe shock. The product is covered by a two-year warranty, unless otherwise stated. The guarantee does not apply to any damage caused by non-standard usage, mechanical damage, exposure to severe conditions or by handling it in contradiction to the manual recommendations, as well as damage caused by ordinary wear and tear.

  • Neither the manufacturer, importer nor the distributor take responsibility for any damage caused by the assembly or incorrect usage of the product.

  • Do not peel off the protective tape covering the sealing bar.

Box Contents

**** **** **** ****
Vacuum sealer AC power cord Tubing Roll

of film
1×| 1×| 1×| 1 roll (28 × 300 cm)

Control Panel

Note: If multiple lights flash at the same time after continuous operation, overheating protection has been activated. Wait 5–10 minutes for the device to cool down and return to normal mode.

  1. DRY/MOIST FOOD SELECT BUTTON
    Sealing takes longer with moist foods than with dry foods. The relevant indicator lights up when the appropriate function is selected.

  2. SEAL BUTTON
    Press to seal whether or not the air has been extracted from the bag. (Wait 30 seconds between sealing’s for the device to cool down).

  3. VACUUM AND SEAL BUTTON
    This is the most used feature. Extract air and seal the bag at the touch of a single button. (Wait 60 seconds between uses for the device to cool down).

  4. STOP AND PULSE VACUUM BUTTON
    Press the STOP button to immediately stop the current operation. In standby mode, press and hold the PULSE/STOP button to activate the pulse function. After initiating the pulse vacuum, with this button the operator can manually control the vacuum pressure according to the type of food. After achieving the desired level of air extraction, release the button and press SEAL to seal the bag.

  5. INDICATOR LIGHTS
    While the VAC SEAL/SEAL/PULSE functions are in operation, the indicator lights will be on.

PRODUCT FEATURES

  1. SILICONE CONTACT PANEL
    Works with silicone seal for optimal sealing.

  2. FOAM SEAL
    Ensures the vacuum chamber is airtight, guaranteeing the bag is properly vacuumed.

  3. VACUUM NOZZLE
    Used to remove air from bags/containers/bottles. Do not obstruct the vacuum nozzle when vacuuming the bag. The hose is used
    when vacuuming a container or bottle.

  4. VACUUM CHAMBER
    Airtight vacuum chamber.

  5. SEAL TAPE
    Works with the silicone contact panel to enable sealing.

  6. ACCESSORY BUTTON
    Before vacuuming using bottle stoppers and vacuum containers, a vacuum tube must be connected. Press this button with the flashing light to start extracting air from a bottle or container. When a certain negative pressure is reached, it stops automatically.

  7. BUILT-IN STORAGE SPACE FOR FILM
    The width of the bag must not exceed 30 cm.

  8. BUILT-IN CUTTER
    Open the top lid, pull out the desired length of bag, hold the bag with one hand and swipe the cutter over the film to get the desired bag length.

OPERATING INSTRUCTIONS

  1. Pull out the bag and swipe the cutter over the film to get the necessary bag length.
  2. Insert the open end of the bag into the vacuum chamber. Please do not obstruct the vacuum nozzle.
  3. Close the lid and press at both ends. If the lid closes properly, you will hear a „click“. Then start sealing or vacuum and sealing.
  4. After the light goes out, the process is complete. Unlock the button on both sides and remove the sealed bag.

BAG/FILM CUTTER TIP

Open the top lid, pull out the desired length of bag, hold the bag with one hand and run the cutter over the film to obtain the desired length of bag

Troubleshooting

  1. Nothing happens when the power cord is plugged into the device.
  2. Make sure that the power cord is not damaged.
  3. Make sure that the power cord is properly plugged into the power socket and the device.
  4. The device is plugged in but cannot vacuum.
    • Make sure that the lid is closed properly.
    • Make sure that the open end of the bag is correctly placed in the vacuum chamber.
    • If the light is flashing, the device may have overheated. Allow it to cool down for a few minutes and try using it again.
    • Check that the bag is not punctured.
    • Check that the foam seal is not deformed or damaged.
  5. The air was extracted from the bag, but now air has penetrated the bag again.
    • Check that there is no hole or puncture in the bag. Sharp objects may have pierced it. If necessary, use a  new bag.
    • Check the sealed edge. Any fold along the sealed edge can cause air penetration. If you find a fold, simply cut the sealed edge and seal it again.
    • If there is moisture or liquid at the open end of the bag, cut off the bag and wipe it off. Then select the MOIST food setting and seal again.
    • If food has been kept for a long time and the bag is filled with gases, the food might be spoiled, and it is advisable to dispose of it.

Note:

  1. To prevent the device from overheating, allow it to cool down for 60 seconds between uses. Leave the lid open for faster cooling.
  2. If the bag melts, the sealing tape may have overheated. Allow the device to cool down for 60 seconds between uses.
  3. To best preserve food, do not reuse the bags after storing raw meat, fish, or fatty foods. Do not reuse bags after cooking or heating in the microwave oven.

USEFUL ADVICE

  1. Do not overfill the bag. Always leave at least 6cm between the contents of the bag and the top edge of the bag.
  2. Clean the open edge of the bag inside and outside. Smooth the open edge of the bag.
  3. When vacuuming a large item, gently spread the bag to smooth the folds before placing it in the vacuum chamber.
  4. Ensure that the bag is dry. A wet bag is difficult to seal tightly.
  5. For best results, perishable food should be frozen or stored in the refrigerator after vacuuming and sealing.
  6. If you vacuum and seal items with sharp edges (such as dry spaghetti, silver items, etc.), protect the bag from punctures by wrapping the item with a soft material such as a paper towel. Instead of a bag, you can use a container.
  7. When using containers, always leave a space of 2.5cm at the top of the container.
  8. If you are not sure that the bag is properly sealed, simply seal it again.
  9. For best results, use bags and containers supplied by the manufacturer.
  10. Microwave: The bag must be pierced before heating in the microwave oven.

CLEANING AND MAINTENANCE

  • Unplug the device before cleaning.
  • Wipe the outer surface down with a soft, soapy cloth. Wipe any food or liquids in the vacuum chamber with a paper towel.
  • Dry the device thoroughly before using it again.
  • Do not immerse the device in water or other liquids. Do not allow water or other liquids to enter the power cord inlet on the device.
  • To prevent damage to the surface, do not clean the device with abrasive cleaners.

NTC thermistor for temperature measurement:
Smart monitoring of the device temperature. When the device overheats, overheating protection mode is automatically activated, the LEDs start flashing and the device cannot be used. The device can be used normally again after it has cooled down and the lights have stopped flashing.

STORAGE INSTRUCTIONS

In the refrigerator (5±2°C)| Shelf-life in normal storage| Shelf-life when using our vacuum and sealing equipment
---|---|---
Meat Seafood and fish Cooked meat Vegetables Fruit Eggs| 2–3 days
1–3 days
4–6 days
3–5 days
5–7 days
10–15 days| 8–9 days
4–5 days
10–14 days
7–10 days
14–20 days
30–50 days
In the freezer (-16±20°C)| Shelf-life in normal storage| Shelf-life when using our vacuum and sealing equipment
Meat Seafood and fish| 3–5 months
3–5 months| 1 year
1 year
Room temperature (25±2°C)| Shelf-life in normal storage| Shelf-life when using our vacuum and sealing
equipment
Bread Rice/flour Peanuts/beans Tea leaves| 1–2 days
3–5 months
3–6 months
5–6 months| 6–8 days

1 year
1 year
1 year

  1. The symbol on the product and in the documentation indicates that used electronics shall not be disposed of into communal waste. When disposing of appliances, take them to the designated waste collection yard, where they will be accepted for free. Proper disposal will help to preserve precious natural resources and protect the environment as well as public health, which both may get threatened by improper disposal and its consequences. For further detail contact the local authorities or the nearest waste collection yard. Improper disposal of electrical appliances may result in fining in compliance with state regulations. Disposal information for users of electrical and electronic appliances (industrial use): Disposal information for users of electrical and electronic appliances are to be asked for at and provided by the seller or supplier. Disposal information for users of electrical and electronic appliances in countries outside of the European Union: The disposal symbol stated above is valid only in the European Union. The disposal symbol stated above  is valid only in the European Union Disposal information for users of electrical and electronic appliances are to be asked for at and provided by the seller or supplier. All information is represented by the crossed.
  2. Repairs within the warranty period are to be claimed at the seller. In case of technical difficulties or questions, please contact the seller, who will inform you about the further procedure. Observe the rules for work with electrical appliances. The user is not authorized to dismantle the product nor to replace any part of it. Open or removed covers present a risk of electrical shock. Incorrectly assembled appliance also presents the risk of electrical shock when re-plugged.

The warranty period is 24 months unless stated otherwise. The warranty does not cover damage caused by non-standard usage, mechanical damage, exposure to extreme conditions, usage contrary to the manual, as well as ordinary wear and tear.

The manufacturer, importer or distributor will not be held responsible for any damage caused by improper usage of the product.

Compliance Statement

Elem6 s.r.o. hereby declares that all Lauben appliances comply with the fundamental requirements as well as other relevant provisions of Directive 2014/30/EU and 2014/35/EU. The products are designated for unrestricted sale in Germany, the Czech Republic, Slovakia, Poland, Hungary and other EU member states. The Compliance Statement can be found on: www.lauben.com/support/doc

Import to EU

elem6 s.r.o., Braškovská 308/15, 16100 Praha 6 www.lauben.com

Manufacturer:
TIGMON GmbH, Yorkstraße 22; 93049 Regensburg, Deutschland

Printing errors and changes in the manual are reserved.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals