SCX design W14.30L Wireless Base Hexa Instruction Manual
- June 4, 2024
- SCX Design
Table of Contents
Instruction Manual
SCX Design® Bamboo Hexa Wireless Charger 10W
Reference W14.30L / 32493
Product Specifications
Material: Bamboo & ABS with soft-touch finish
Item dimension: 85x100x11mm
Weight: 60g
Micro input: 5V/2A – 9V/2A
Wireless output: DC 5V/1A, 9V/1.12A
Output: 10W
The product includes a micro USB charging cable.
Key functions
Functionalities
Connect the USB cable to the USB port of a wall adapter or of your laptop
(A).
Make sure your phone is compatible with wireless charging.
Put your wireless charging enabled device on the wireless charging surface
(B)
Warning!
Some phone cases may block the wireless charging. Do not place other
materials between the mobile device and the wireless charger pad.
Check your mobile device’s battery percentage using the charging icon
displayed on the screen of your phone.
When the mobile device is not placed on the charging surface accurately, your
mobile device may not charge properly. Please do not expose this device to
moisture or heat sources
Keep the product out of reach of children.
Using your phone while charging it can cause higher temperatures.
Never Store or use this product in temperatures below 32°F (0°C) or above
115°F (45°C).
Imported by SCX Design 68 bis boulevard Pereire 75017 Paris France
IMPORTER FOR USA AND CANADA
IMPORTATEUR POUR LES ETATS-UNIS ET LE CANADA
Distributed by Koozie Group
Distribué par Koozie Group
14421 Myerlake Circle
Clearwater, FL 33760
USA
SAFETY WARNING
In order to prevent conditions. that can lead to overheating, please make sure that the wireless charging pad surface is free of all metal objects at all times, such as coins or paper clips. In addition, before charging, please remove anything metallic attached to the back of the phone, such as battery cases, ring holders, or plates used for mounting to magnetic phone holders.
** FCC compliance statement**
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1)this device may not cause harmful
interference, and (2)this device must accept any interference received,
including interference that may cause undesired operation. changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
13 digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC’s RF radiation exposure limits set forth for an
uncontrolled environment. A separation distance of 20 cm or more should be
maintained between this device and persons during device operation. To ensure
compliance, operation at closer to this distance is not recommended.
The antenna used for this transmitter must not be co-located in conjunction
with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>