SCX design W13-32486 Maple Wood 10W Wireless Charger Instruction Manual

June 5, 2024
SCX Design

SCX design W13-32486 Maple Wood 10W Wireless Charger

SCX design
W13-32486 Maple Wood 10W Wireless Charger logo

SCX Design® Maple Wood 10W Wireless Charger
Reference W13/32486, W12/32484

Please read the instruction manual carefully before using the product.

Product Specifications

  • Material: ABS wih soft touch finish
  • Item dimension: ø68×10.2mm
  • Weight: 32g
  • Micro input: 5V/2A, 9V/2A
  • Wireless output: DC 5V/1A, 9V/1.12A
  • Output: 10W

The product includes a micro USB charging cable.

Key functions

SCX design W13-32486 Maple Wood 10W Wireless Charger fig
1

Functionalities

Connect the wireless charger the micro USB cable to the wireless charging pad (A), connect the USB to the USB port of your PC/laptop or charger.
Make sure your phone is compatible for wireless charging.
Put your wireless charging enabled device on the wireless charging surface (B)

Warning!

Some phone cases may block the wireless charging. Do not place other materials between the mobile device and the wireless charger pad.
Check your mobile device’s battery percentage using the charging icon displayed on the screen of your phone.
When the mobile device is not placed on the charging surface accurately, your mobile device may not charge properly. Please do not expose this device to moisture or heath sources
Keep the product out of reach of children.

Using your phone while charging it can cause higher temperatures. This product complies with European Directive 2002/96 / EC on
waste electronic and electronic equipment (WEEE) and 2011/65 / EU & 2015/863/EU on the use of certain hazardous substances in electrical and electronic equipment (RoHS).

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that maycause undesired operation.
Never Store or use this product in temperatures below 32°F (0°C) or above 115°F (45°C).  SCX design W13-32486 Maple Wood 10W Wireless Charger fig
1

Imported by SCX Design
68 bis boulevard Pereire
75017 Paris
France

IMPORTER FOR USA AND CANADA
Distributed by Koozie Group
14421 Myerlake Circle
Clearwater, FL 33760
USA SCX design W13-32486 Maple Wood 10W Wireless Charger fig
1

FCC compliance statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.
    changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
    This device complies with FCC’s RF radiation exposure limits set forth for an uncontrolled environment. A separation distance of 20 cm or more should be maintained between this device and persons during device operation. To ensure compliance, operation at closer than this distance is not recommended.
    The antenna used for this transmitter must not be co-located in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

SCX Design User Manuals

Related Manuals