Scx Design H1630L Wireless Charger & 4 Hub Instruction Manual
- June 5, 2024
- SCX Design
Table of Contents
Scx Design H1630L Wireless Charger & 4 Hub
Ref Hl6/32469 – 5W wireless hub with lighting logo Please read the instruction manual before use.
Product Specifications
- Material: ABS soft-touch finish
- Item dimension: Ø73x19mm
- Weight:67g
- Input: DC 5V/2A
- Output: DC 5V/1A
- Wireless output: DC 5V/1A – 5W
Product overview:
This device is equipped with a type C plug adaptable to the USB port for connection to different USB and C plugs.
Includes a USB connection cord with adapter (male / female), total length 30 cm
Wireless charging
Connect the USB to the USB port of your PC/laptop or charger Make sure your
phone is compatible for wireless charging. Put your wireless charging enabled
de surface. rice on the wireless charging
Warning!
Some phone cases may block the wireless charging. Do not place Pad other
materials between the mobile device and the wireless charger Check your moble
device’s battery percentage using the charging icon displayed on the screen of
your phone. When the mobile device is not placed on the charging surface
accurately, your mobile device may not charge properly. Please do not expose
this device to moisture or heath sources Keep the product out of reach of
children. Using your phone while charging it can cause higher temperatures.
This product complies with European Directive 2002/96 / EC on waste electronic
and electronic equipment (WEEE) and 2011/65/ EU & 2015/863/EU on the use of
certain hazardous substances in electrical and electronic equipment (RoHS).
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: this device may not cause harmful interference,
and this device must accept any interference
received, including interference that may cause undesired operation. changes
or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment. This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC’s RF radiation exposure limits set forth for an
uncontrolled environment. A separation distance of 20 cm or more should be
maintained between this device and
persons during device operation. To ensure compliance, operation at closer
than this distance is not recommended. The antenna used for this transmitter
must not be co-located in COnunetion with anv other antenna or trancrnittar
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>