SCX Design P35.30L Maple Wood Power Bank 5000 mAh Instruction Manual
- June 5, 2024
- SCX Design
Table of Contents
SCX Design P35.30L Maple Wood Power Bank 5000 mAh
Please read the instruction manual carefully before using the product.
Specification
- P35: 125 x 70 x 11 mm
- P36 P37: 125 x 70 x 127 mm
- Input 5V/2A
- Output 5V/2A
- Output: 5W
- This product comes with a 3-in-1 charging cable (iPhone, Micro, Type C).
Functionalities
-
LED indicator to show remaining power
-
Dual USB output ports for different devices
-
Multiple safety protection systems to ensure the safety of the devices:
protection in the event of overload, overvoltage, overcurrent, and short circuit. -
The remaining charge power is displayed by shaking the product it can fully charge an iPhone, an Android device or any other regular mobile phone once per load cycle.
- To charge your power bank, connect the supplied cable to your USB wall charger or to a USB port on your computer. Plug the micro USB in to the power bank. When fully charged, unplug the power bank.
- To charge your phone or another mobile device, plug the cable into the USB port of the power bank. Plug the other end of the cable into your device.
When the power bank is fully charged, the blue light will remain on. 
Wireless functionalities
- When the wireless powerbank is fully charged, the light is always on.
- When the wireless powerbank is charging or fully charged put your smartphone on the side with the wireless logo of the powerbank to charge your smartphone wirelessly or charge your smartphone via the USB output via the provided 3-in-1 cable.
- When the wireless powerbank has no charge, the blue LED light will be turned off.
Warning!
- Due to system updates of your smartphone the included cable might not work any longer. In this case we recommend the usage of the original cable.
- Do not place or use this product near a source of high heat or in a humid environment.
- Do not use if the equipment is damaged.
- Only use the cables that are supplied with this equipment.
- Keep the product out of reach of children.
- If the charger hasn’t been used for a long time, please charge/unload it once every 3 months to preserve the functionality of the product.
- Using your phone while charging it can cause high temperatures
- Never Store or use this product in temperatures below 32°F (0°C) or above 115°F (45°C).
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC’s RF radiation exposure limits set forth for an
uncontrolled environment. A separation distance of 20 cm or more should be
maintained between this device and persons during device operation. To ensure
compliance, operation at closer than this distance is not recommended.
The antenna used for this transmitter must not be co-located in conjunction
with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>