LeoVince 15007-15007B Slip On Classic Racer, Classic Racer Black Instruction Manual
- June 3, 2024
- LeoVince
Table of Contents
LeoVince 15007-15007B Slip On Classic Racer, Classic Racer Black
LIST OF COMPONENTS
- Muffler RHS
- Muffler LHS
- Clamp
- Bracket RHS
- Bracket LHS
- Fitting kit
FITTING INSTRUCTION
LIST OF SUPPLIED PARTS
Refer to the list of components and the product drawing included in this
booklet.
WARNING
before carrying out any work on the exhaust, check that its surface has cooled
so that it will not damage components, which are not heat-resistant (such as
fairing, hoses, rubber sleeves, etc.), or the operator.
INSTALLATION
- Remove the OE silencer.
- Check that the mating surfaces are in good clean condition, slide the link pipe on to the original header, taking care not to damage the graphite bushing (if supplied) which should replace the OE bushing. Partially tighten the securing strap to allow a degree of further adjustment.
- Slide the Leovince silencer onto the link pipe, check the alignment of the mounting eyes for the springs and the alignment of the exhaust outlet to the rear of the silencer, and then link the parts together with the springs provided
- Mount spacers, washers and brackets (if any) as shown on the drawing and then secure by tightening nuts and bolts.
- Tighten the various clamps which join the Leovince link pipe to the OE exhaust hea-ders.
- Start the engine, wait a few minutes until it reaches operating temperature, and check that there are no gas leaks.
IMPORTANT
During the first km of running, the exhaust system needs breaking-in;
therefore, slight gas leakage might occur. After approximately 100 Km, check
all the fasteners.
It is normal for some white smoke to appear the first time you use the
exhaust, even after switching off the engine.
ADJUSTMENT
This silencer has been developed by Leovince on an electronic dynamometer using a vehicle in perfect condition, and in standard trim
MAINTENANCE
From time to time, check all the brackets and fasteners, which could be affected by use (sound-deadening material, seals and other rubber parts) and replace them periodically. The silencer may be cleaned using gasoline, diesel oil or alcohol. Absolutely avoid the use of any kind of solvent.It is normal for there to be some discolouration of the silencer, which is the result of heat and the nature of the materials used.
IT IS FORBIDDEN to modify silencers. Whatever form this may take, Belgrove Sp. z o.o. declines any responsibility for defects, problems, or malfunction, arising from the use of any product which has been modified or tampered with. We suggest the fitting to be made by professionals
PESO – WEIGHT – POIDS – GEWICHT (Kg)
ORIGINALE – STOCK – ORIGINE – ORIGINAL 5,15 (Kg)
| Stainless steel| S.s. Black| Titanium
LeoVince
|
4,31
|
4,31
|
/
ART.15007
ROYAL ENFIELD CONTINENTAL GT 650 / INTERCEPTOR 650 SLIP-ON – CLASSIC RACER – STAINLESS STEEL
ART.15007B
ROYAL ENFIELD CONTINENTAL GT 650 / INTERCEPTOR 650 SLIP-ON – CLASSIC RACER – BLACK
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>