LeoVince 15250FB Exhaust Muffler Instruction Manual
- June 10, 2024
- LeoVince
Table of Contents
LeoVince 15250FB Exhaust Muffler
FITTING INSTRUCTION
LIST OF SUPPLIED PARTS
Refer to the list of components and the product drawing included in this booklet.
WARNING
before carrying out any work on the exhaust, check that its surface has cooled so that it will not damage components, which are not heat-resistant (such as fairing, hoses, rubber sleeves, etc.), or the operator.
INSTALLATION
-
Remove the original silencer. (Photo 1-2-3-4-5)
-
Check that the mating surfaces are in good clean condition, slide the link pipe on to the original header, taking care not to damage the graphite bushing (if supplied) which should replace the OE bushing. Partially tighten the securing strap to allow a degree of further adjustment.
-
Attach the support bracket to the motorcycle frame using the supplied screw. (Photo 5)
-
Slide the Leovince silencer onto the link pipe, check the alignment of the mounting eyes for the springs and the alignment of the exhaust outlet to the rear of the silencer, and then link the parts together with the springs provided
-
1Mount spacers, washers and brackets (if any) as shown on the drawing and then secure by tightening nuts and bolts. (Photo 6)
-
Tighten the various clamps which join the Leovince link pipe to the OE exhaust headers.
-
Start the engine, wait a few minutes until it reaches operating temperature, and check that there are no gas leaks.
IMPORTANT:
During the first km of running, the exhaust system needs breaking-in; therefore, slight gas leakage might occur. After approximately 100 Km, check all the fasteners.
ADJUSTEMENT:
This silencer has been developed by Leovince on an electronic dynamometer using a vehicle in perfect condition, and in standard trim.
MAINTENANCE:
From time to time, check all the brackets and fasteners, which could be affected by use (sound-deadening material, seals and other rubber parts) and replace them periodically. The silencer may be cleaned using gasoline, diesel oil or alcohol. Absolutely avoid the use of any kind of solvent.It is normal for there to be some discolouration of the silencer, which is the result of heat and the nature of the materials used.
IT IS FORBIDDEN to modify silencers. Whatever form this may take, Belgrove Sp. z o.o. declines any responsibility for defects, problems, or malfunction, arising from the use of any product which has been modified or tampered with.
We suggest the fitting to be made by professionals
PARTS SPECIFICATIONS
ART. 15250FB
DUCATI SCRAMBLER 800 ICON / DARK (also fits 35kW version)
SLIP-ON – LV-10 – FULL BLACK
ART. 15250FB – SPARE PARTS
DUCATI SCRAMBLER 800 ICON / DARK (also fits 35kW version)
**A**FITTIG KIT cod.3015250602R
PESO – WEIGHT – POIDS – GEWICHT (Kg)
ORIGINALE – STOCK – ORIGINE – ORIGINAL| 6,68 (Kg)
| Stainless steel| S.s full black| Titanium
LeoVince| /| 1,31| /
1 – Muffler
2 – Link pipe
3 – Fitting kit
BLACK
cod. 3015239410
cod. 3015250221
cod. 3015250602
CUSTOMER SUPPORT
leovince.com –
[email protected]
Europe Customer Service: [email protected]
USA Customer Service: [email protected]
– +1-844-536-7625
