LeoVince 3399M GP Corsa EVO Slip-On Exhaust Instruction Manual
- June 10, 2024
- LeoVince
Table of Contents
TECHNICAL INFORMATION
ART. 3399M
SLIP-ON
GP CORSA MATTE
KTM DUKE 125
TYPE: KTM IS DUKE; KTM 125 Duke
PHOTO 1
LIST OF COMPONENTS
1 – Muffler
2 – Link pipe
3 – Fitting kit
4 – clamp
5 – Db-Killer| CARBON FIBER
cod. 303396471
cod. 3015249201
cod. 3015249601
cod. 303396501
cod. 303457801
---|---
WEIGHT (Kg)
STOCK 2,3 (Kg)
| Stainless stee| Carbon| Titanium
LeoVince| /| 1.37| /
FITTING INSTRUCTION
LIST OF SUPPLIED PARTS:
Refer to the list of components and the product drawing included in this
booklet.
WARNING :
before carrying out any work on the exhaust, check that its surface has cooled
so that it will not damage components, which are not heat-resistant (such as
fairing, hoses, rubber sleeves, etc.), or the operator.
INSTALLATION:
- Remove the original silencer.
- Check that the mating surfaces are in good clean condition, slide the link pipe on to the original header, taking care not to damage the graphite bushing (if supplied) which should replace the OE bushing. Partially tighten the securing strap to allow a degree of further adjustment.
- Slide the Leovince silencer onto the link pipe, check the alignment of the mounting eyes for the springs and the alignment of the exhaust outlet to the rear of the silencer, and then link the parts together with the springs provide Fit the clamps to the silencer. mount spacers, washers and brackets (if any) as shown on the drawing and then secure by tightening nuts and bolts. (PHOTO 1)
- Fit the clamps to the silencer. mount spacers, washers and brackets (if any) as shown on the drawing and then secure by tightening nuts and bolts. (PHOTO 1)
- Tighten the various clamps which join the Leovince link pipe to the OE exhaust headers.
- Start the engine, wait a few minutes until it reaches operating temperature, and check that there are no gas leaks.
IMPORTANT:
During the first km of running, the exhaust system needs breaking-in; therefore, slight gas leakage might occur. After approximately 100 Km, check all the fasteners.
ADJUSTEMENT:
This silencer has been developed by Leovince on an electronic dynamometer using a vehicle in perfect condition, and in standard trim
MAINTENANCE:
From time to time, check all the brackets and fasteners, which could be
affected by use (sound-deadening material, seals and other rubber parts) and
replace them periodically. The silencer may be cleaned using gasoline, diesel
oil or alcohol. Absolutely avoid the use of any kind of solvent.It is normal
for there to be some discolouration of the silencer, which is the result of
heat and the nature of the materials used.
IT IS FORBIDDEN to modify silencers. Whatever form this may take,
Belgrove Sp. z o.o. declines any responsibility for defects, problems, or
malfunction, arising from the use of any product which has been modified or
tampered with.
We suggest the fitting to be made by professionals
leovince.com –
info@leovince.com
Europe Customer Service: info@leovince.com
USA Customer Service: infousa@leovince.com –
+1-844-536-7625
ART. 3399M
Given name……………………
Surname/Nom……………………….
Address……………………………..
Vehicle registration plate……………….
Tel…………………….
Date and seller’s stamp
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>