DV8 OFFROAD DMBR-01 Digital Device Dash Mount Installation Guide
- June 13, 2024
- DV8 OFFROAD
Table of Contents
PRODUCT
INSTALLATION MANUAL
DMBR-01 Digital Device Dash Mount
DASH MOUNT
2021+ FORD BRONCO
DMBR-01
TOOLS REQUIRED | SKILL LEVEL | TIME REQUIRED |
---|---|---|
-4mm Allen BIt | Novice | – .5 Hour |
Ratchet | – 1 (you) to 2 persons | Time to install this should only take about |
half an hour
| Little skill level required, you can easily install it by yourself.|
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
Before you install this kit — Read and understand all instructions, warnings,
cautions, and notes contained in this installation instruction guide. Consult
your vehicle owner’s manual for proper disconnection of electrical and lifting
of vehicle if required for installation of this product.
This install may require some technical skills and knowledge of basic
mechanical work. If you do not feel that you are capable of performing this
install please take this product to a trained professional.
After reading this guide please contact us with any questions or concerns
before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you or your
vehicle as a result of an improper install.
Proper installation of this kit required knowledge of the factory recommended
procedures for removal and installation of original equipment components. We
recommend that the factory shop manual and any special tools needed to service
your vehicle be on hand during the installation. Installation of this kit
without proper knowledge of the factory recommended procedures may affect the
performance of these components and the safety of the vehicle
- Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged and all installation hardware has been included. If parts are missing from kit, please be prepared to provide the following information
- Name of purchase location
- Bar Code on side of box
- Date above bar code
- Date inside box cover
STEP 1
Begin by unpacking all items and inspecting for missing pieces or damage. If
you have any concerns, please contact the company the product was purchased
from.
HARDWARE INCLUDED
(1) 1/4”-20×3/4” Allen Head STEP 2
Place the DV8 dash mount onto the center of the dash lining up the mounting
hole on the dash mount with the accessory ready hole provided on the dash.
If you have a Raptor model Bronco, you can either remove the USB cover
completely, or rotate it so the cap will be underneath the dashmount once it
is installed. STEP 3
Secure the dash mount using the provided ¼”-20 hardware and a 4mm allen
bit. STEP 4
Double check fitment and hardware is secure. Congratulations, you are finished
with the install of the DV8 Bronco Dash Plate.
NEED HELP?
855-680-9595
Documents / Resources
| DV8
OFFROAD DMBR-01 Digital Device Dash
Mount
[pdf] Installation Guide
DMBR-01, DMBR-01 Digital Device Dash Mount, Digital Device Dash Mount, Device
Dash Mount, Dash Mount, Mount
---|---