LeoVince 15220FB LV-10 Slip-On Exhaust Instruction Manual
- June 10, 2024
- LeoVince
Table of Contents
ART. 15220FB
SLIP-ON
LV-10 FULL BLACK
HUSQVARNA SVARTPILEN 701 / VITPILEN 701
(also fits 33 kW version)
TYPE: HQV 701; A/-, B/-
TECHNICAL INFORMATION
LIST OF COMPONENTS
- Muffler
- Link pipe
- Fitting kit
PESO – WEIGHT – POIDS – GEWICHT (Kg)
ORIGINALE – STOCK – ORIGINE – ORIGINAL 3,47 (Kg)
| Stainless steel| Full Black| Titanium
---|---|---|---
LeoVince| /| 1,40| /
ART. 15220FB
HUSQVARNA SVARTPILEN 701 / VITPILEN 701 (also fits 33 kW version)
SLIP-ON – LV-10 – FULL BLACK
ART. 15220FB – SPARE PARTS
HUSQVARNA SVARTPILEN 701 / VITPILEN 701 (also fits 33 kW version)
A FITTING KIT Cod.3015220601R
FITTING INSTRUCTION
LIST OF SUPPLIED PARTS:
Refer to the list of components and the product drawing included in this
booklet.
WARNING:
before carrying out any work on the exhaust, check that its surface has cooled
so that it will not damage components, which are not heat-resistant (such as
fairing, hoses, rubber sleeves, etc.), or the operator.
INSTALLATION:
-
Remove the OE silencer.
-
Check that the mating surfaces are in good clean condition, slide the link pipe on to the original header, taking care not to damage the graphite bushing (if supplied) which should replace the OE bushing. Partially tighten the securing strap to allow a degree of further adjustment.
-
Slide the Leovince silencer onto the link pipe, check the alignment of the mounting eyes for the springs and the alignment of the exhaust outlet to the rear of the silencer,
and then link the parts together with the springs provided -
Mount spacers, washers and brackets (if any) as shown on the drawing and then secure by tightening nuts and bolts.
-
Tighten the various clamps which join the Leovince link pipe to the OE exhaust headers.
-
Start the engine, wait a few minutes until it reaches operating temperature, and check that there are no gas leaks.
IMPORTANT:
During the first km of running, the exhaust system needs breaking-in;
therefore, slight gas leakage might occur. After approximately 100 Km, check
all the fasteners.
ADJUSTEMENT:
This silencer has been developed by Leovince on an electronic dynamometer
using a vehicle in perfect condition, and in standard trim
MAINTENANCE:
From time to time, check all the brackets and fasteners, which could be
affected by use (sound-deadening material, seals and other rubber parts) and
replace them periodically.
The silencer may be cleaned using gasoline, diesel oil or alcohol. Absolutely
avoid the use of any kind of solvent.It is normal for there to be some
discolouration of the silencer, which is the result of heat and the nature of
the materials used.
IT IS FORBIDDEN to modify silencers. Whatever form this may take, Belgrove Sp.
z o.o. declines any responsibility for defects, problems, or malfunction,
arising from the use of any product which has been modified or tampered with.
We suggest the fitting to be made by professionals
Given name_
Surname___
Address____
Vehicle registration plate
Tel.____
Date and seller’s stamp
NOTES___
leovince.com
International Customer Service: info@leovince.com
North America Customer Service:
infousa@leovince.com –
+1-844-536-7625
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>