LeoVince ART. 15248C Slip On LV-10 Carbon Instruction Manual
- June 3, 2024
- LeoVince
Table of Contents
LeoVince ART. 15248C Slip On LV-10 Carbon Instruction Manual
LIST OF COMPONENTS
- Muffler
- Link pipe
- Fitting kit
- Heat shield
| WEIGHT | (Kg) |
|---|---|
| STOCK | 5,80 (Kg) |
| Stainless stee | |
| LeoVince | / |
DESCRIPTIONS
ART. 15248C
APRILIA RSV4 1100 / FACTORY – TUONO V4 1100 / FACTORY
SLIP-ON – LV-10 – CARBON
ART. 15248C – SPARE PARTS
APRILIA RSV4 1100 / FACTORY – TUONO V4 1100 / FACTORY
- A FITTING KIT cod.3015248601R
- B CARBON COVER KIT cod.308720001R
FITTING INSTRUCTION
LIST OF SUPPLIED PARTS:
Refer to the list of components and the product drawing included in this
booklet.
WARNING:
before carrying out any work on the exhaust, check that its surface has cooled
so that it will not damage components, which are not heat-resistant (such as
fairing, hoses, rubber sleeves, etc.), or the operator.
INSTALLATION:
-
If present, remove the complete fairing. Remove the original silencer(s) and remove the two valve actuation cables according to the instructions (photo 1, photo 2).
Remove the two fixing screws, then rotate the servomotor 180 degrees to access the non-visible side where the valve actuation cables are located.
Disconnect the connector connected to the servomotor, then remove the two cables by removing them permanently from the frame. Reconnect the connector and reassemble in reverse order to secure the servomotor again. -
Check that the mating surfaces are in good clean condition, slide the link pipe on to the original header, taking care not to damage the graphite bushing (if supplied) which should replace the OE bushing. Partially tighten the securing strap to allow a degree of further adjustment.
-
Slide the Leovince silencer onto the link pipe, check the alignment of the mounting eyes for the springs and the alignment of the exhaust outlet to the rear of the silencer, and then link the parts together with the springs provided
-
Fit the clamps to the silencer. Mount spacers, washers and brackets (if any) as shown on the drawing and then secure by tightening nuts and bolts.
PHOTO 1
PHOTO 2
PHOTO 3
PHOTO 4
PHOTO 5
PHOTO 6
Given name: ___
Surname/Nom: ___
Address: ___
Vehicle registration plate: ___
Tel.:___
Date and seller’s stamp: ___
Ieovince.com – info@leovince.com
Europe Customer Service:
info@leovince.com
USA Customer Service:
infousa@leovince.com –
+1-844-536-7625
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>