Secukey S1-RX Series Reader Controller User Guide
- June 6, 2024
- Secukey
Table of Contents
Secukey S1-RX Series Reader Controller User Guide
1. Introduction Wiring
The S-RX Series readers are advanced 125 KHz & 13.56 MHz technology proximity readers, with built-in Light Dependent Resistor (LOR) sensor for anti-tamper, it is an ideal choice for high-security applications. T hey are attractively designed with a thin profile and modem appearance, four models (S1-RX, S2-RX, S3-RX and S4-RX) available.
2. Specifications
3. Installation
- Drill 2 holes (A, C) on tile wall for the screws and one hole for the cable
- Knock the rubber bungs to the holes(A,C)
- Fix the back cover on the wall with 2 screws
- Thread the cable though the cable hole (B)
- Attach the unit to the back cover
Wiring
Connection Diagram
4. Functions Table Sheet
5. Data Signal
Packing List
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1 )This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However.
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference lo radio or
television reception. which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The dev ice has been evaluated to meet genera l RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>