Maxxima MEW-RS100W Single Pole Combination Rocker Light Switch Installation Guide

June 3, 2024
Maxxima

Maxxima-MEW-RS100W-Single-Pole-Combination-Rocker-Light-Switch-
logo

Maxxima MEW-RS100W Single Pole Combination Rocker Light Switch

Maxxima-
MEW-RS100W-Single-Pole-Combination-Rocker-Light-Switch-
product

WARNINGS

  • Risk of electric shock – Disconnect power at the source before installation.
  • If you are unsure about the installation or the maintenance of the wall light, please consult an electrician.
  • Use only copper or copper-clad wire.

CAUTIONS

  • To ensure personal safety, proper grounding of the electrical fixture is required.
  • The fixture must be wired in accordance with the National Electric Code and applicable local codes or ordinances.

SPECIFICATION

  • 15A 60Hz 120VAC – 1800W Max – Separate Feed Wiring Capable
  • Maximum Tightening Torque: 14 in-lbs (1.6 Nm)

INSTALLATION INSTRUCTIONS

Tools Needed: Screwdriver, wire nuts, electrical tape.
If you are replacing an existing fixture, remove and disconnect the old fixture first.
Note: For Separate Feed and/or Switched Outlet Configuration wiring, the break-off fin located in between the dark-colored screws should be removed before wiring. Use a Flat Head screwdriver to bend the fin until it breaks off.

  1. Shut off power at the circuit breaker or fuse. See Warning.
  2. Remove insulation from wires (approximately 3/8″ to 5/8″). The HOT terminals have dark-colored screws. Loop each wire around its respective terminal screw per the diagram below.
  3. Fasten Screws securely. Terminal screws accept up to #12AWG copper or copper-clad wire
  4. Mount the switch using the long mounting screws provided. Attach the wall plate.
  5. Restore power at the circuit breaker or fuse. See Warning.Maxxima-MEW-RS100W-Single-Pole-Combination-Rocker-Light-Switch-fig-1

1 YEAR WARRANTY

  • Risk of electric shock – Disconnect power at the source before installation.
  • If you are unsure about the installation or the maintenance of the wall light, please consult an electrician.
  • Use only copper or copper-clad wire.

CAUTIONS

  • To ensure personal safety, proper grounding of the electrical fixture is required.
  • The fixture must be wired in accordance with the National Electric Code and applicable local codes or ordinances.

WARNINGS
Maxxima extends a 1-year limited warranty to the original purchaser that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product with the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. A limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.

Documents / Resources

| Maxxima MEW-RS100W Single Pole Combination Rocker Light Switch [pdf] Installation Guide
MEW-RS100W, Single Pole Combination Rocker Light Switch, Rocker Light Switch, Light Switch, Single Pole Combination Switch, Switch, MEW-RS100W
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Maxxima User Manuals

Related Manuals