Maxxima MEL-23100W Decorative Outdoor LED Wall Light Sconce Instruction Manual
- October 30, 2023
- Maxxima
Table of Contents
MEL-23100W Decorative Outdoor LED Wall Light Sconce
Instruction Manual
MEL-23100W Decorative Outdoor LED Wall Light Sconce
WARNING:
To avoid fire, shock, or death. Disconnect power at circuit breaker or fuse
before the installation. Wear gloves to prevent cuts/abrasions from sharp
edges when removing from carton, handling, and maintaining this fixture.
SAFETY:
This fixture must be wired in accordance with the National Electric Code and
applicable local codes or ordinance.
If you are unfamiliar with proper electrical wiring connections, please
consult a qualified electrician.
To insure personal safety, proper grounding is required.
IMPORTANT:
Read all instructions carefully before attempting installation.
TOOLS REQUIRED:
Product size:
LIGHT FIXTURE SPECIFICATION:
Input Voltage: 120V AC
Input Frequency: 60 Hz
Rated Power: 23W
WARRANTY:
Maxxima extends a 5 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warranted product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
| 1 | Outlet box |
|---|---|
| 2 | Cross bar bracket |
| 3 | Black supply wire |
| 4 | Twist-on wire nuts connectors |
| 5 | Black fixture wire |
| 6 | 8-32*15 machine tapping screw |
| 7 | M4*14 machine tapping screw |
| 8 | White supply wire |
| 9 | House ground wire (Green) |
| 10 | Fixture ground wire (Green) |
| 11 | White fixture wire |
| 12 | M4*7 hand nuts |
| 13 | Back plate |
INSTALLATIONS:
-
Turn off power at the corresponding circuit breaker.
-
Carefully disconnect and remove the old light fixture.
-
Locate and pull out the supply wires (#3#8#9) from the outlet box (#1).
-
Install the cross bar (#2) on the outlet box (#1) by using the machine tapping screw (#6).Avoid pressing the wires (#3#8#9).
-
Make the wiring connections by using twist-on wire nuts (#4).Do not leave bare conductors exposed.
Connect the white fixture wire (#11) to the white supply wire (#8)
Connect the black fixture wire (#5) to the black supply wire (#3)
Connect the green fixture ground wire (#10) to the green ground wire (#9).If you don’t have a green ground wire, please consult a qualified electrician. -
Adjust the upper cross bar (#2) to be in a horizontal position.
-
Insert the M414 machine tapping screw (#7) through the hole in the back plate (#13) of the fixture, and tighten by using the M47 hand nuts (#12).
MEL-23100W
www.maxximastyle.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>