Winterwarm GA4012 Position Reset Alarm Relay User Guide
- June 13, 2024
- Winterwarm
Table of Contents
Winterwarm GA4012 Position Reset Alarm Relay
Product Information
The product described in the user manual is a relay used in various models of devices. The specific models include XR40-60, HR40-120, XR+ for the first set of instructions, and XR10-30, DXC 60-100, DXA/B for the second set of instructions. The relay is used in different locations within the device, such as under LD (location determined by the device), left of premix-fan, and left of terminal block (self-determined location). The user manual provides instructions for both mounting the relay with the supplied base and mounting it without the base. The instructions also specify the screw hole position for each type of installation. The electrical connections for the relay involve inserting white wires into plug J6 on the circuit board at positions 3 and 10, inserting a long black wire into plug J3 at position 3, and inserting a long blue wire into plug J3 at position 8. The exact wiring connections are illustrated in the figures provided in the manual.
Product Usage Instructions
Mounting with Supplied Base
- Ensure that the device type matches the ones mentioned in the instructions (XR40-60, HR40-120, XR+).
- Determine the correct location for mounting the relay (under LD or left of premix-fan).
- Use the screw hole indicated in Figure 1 to mount the relay.
- Connect the electrical wires as follows:
- Insert the white wires into plug J6 on the circuit board at positions 3 and 10.
- Insert the long black wire into plug J3 at position 3.
- Insert the long blue wire into plug J3 at position 8.
Mounting without Base
- Ensure that the device type matches the ones mentioned in the instructions (XR10-30, DXC 60-100, DXA/B).
- Determine the desired location for mounting the relay (under LD or left of the terminal block).
- Remove the relay from the base by following the steps shown in Figure 2.
- Mount the relay directly on the device using the screw hole shown in Figure 4.
- Refer to page 1 for the electrical connections.