Maxxima MRL-S62405 6 Inch Trimless Downlight Installation Guide
- June 1, 2024
- Maxxima
Table of Contents
6” Trimless Downlight Installation Guide
MRL-S62405
www.maxximastyle.com
MRL-S62405 6 Inch Trimless Downlight
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the fixture, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
CAUTIONS
- The fixture must be wired in accordance with the National Electric Code (N.E.C) standards and any applicable local codes or ordinances.
- Supply conductors must at least be rated for 90°C/194°F.
- This fixture is designed for use with 120Vac, 50/60Hz only.
- Suitable for wet locations.
- Covered ceiling mount only.
INSTALLATION INSTRUCTIONS
- Ensure that power has been turned off by switching the circuit breaker or by removing the fuse from the fuse panel.
- Using the provided template, cutout the required hole, see figure 1.
- Preview and select the desired color temperature using CCT switch, see figure 2.
- Install the plaster frame into the cutout and, using the provided screws, secure the plaster fram to the ceiling, see figure 3.
- Plaster over the plaster frame ensuring not to put too much plaster to fill above the rasied ridge, see figure 4.
- Open the junction box and remove the appropriate knockout and attach a twin screw clamp connector (not provided or necessary).
- Insert the AC power supply wires through the knockout or clamp connector (not provided or necessary).
- Connect the hot (black) wire to the black supply wire, the neutral (white) wire to the white supply wire, and the green (or bare copper) to the ground supply wire using the provided wire nuts, see figure 5.
- Insert the junction box through the plaster frame ensuring it rests on the ceiling material. Then align the locking tabs on the fixture to the tabs on the plaster frame. Rotate fixture until it is secure in the frame, see figure 6 and 7.
- Installation is now complete. Restore power and the light is now operational.
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
info@maxximastyle.com
866-MAXXIMA (629-9462)
www.maxximastyle.com
125 Cabot Court Hauppauge, NY 11788
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>