Maxxima MSL-205000F LED Adjustable Hanging Garage Shop Light Installation Guide
- June 1, 2024
- Maxxima
Table of Contents
Linkable Shop Light Installation Guide
MSL-205000F LED Adjustable Hanging Garage Shop Light
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the wall light, please consult an electrician.
- Do not attempt to open the fixture housing.
- Polarized plug, do not force the plug into an outlet that it does not fit. Do not alter plug.
CAUTIONS
- The device complies with part 15 of FCC standards.
- Not for use with dimmers.
- Suitable for damp locations.
- Do not install directly above a heat source (stove, etc.).
- Screw hooks are to engage the steel wire lanyard only, not the electrical cord.
- Max of 4 lamps can be connected together. MAX 1.41A.
WIRING INSTRUCTIONS
Hanging Installation:
- Install screw hooks into ceiling 23.43” apart, see figure 1. If mouting to plaster, it is recommended to use the supplied plastic wall anchors.
- Insert the steel wire lanyard hooks through the openings on the top of the shop light assembly. Using pliers (not supplied), crimp end of both hooks, see figure 2.
- Attach the steel wire lanyard to the screw hooks, see figure 3.
- Adjust the rotating assembly to the desired lighting angle, see figure 4.
- Insert the plug into a 120V, 60 Hz polar socket.
- Installation is now complete, light is now operational.
Flush Mount Installation:
- Install supplied M4x25 screws and supplied M4x3 nuts on the plastic mounting plate and ensure that the screw head is 0.1” ~0.12” away from the plastic mounting plate, see figure 5.
- Using the supplied ST4x30 screws, secure the hanging plate to the ceiling. If installing into plaster, it is recommended to use the plastic wall anchors. Screws should be 22.83” apart, see figure 6.
- Align shop light to the M4x25 screws and slide light to the left. The shop light should be firmly fixed against the screws. If the shop light is easily moved, remove and tighten screws in mounting plates, see fighure 7.
- Adjust the rotating assembly to the desired lighting angle, see figure 8.
- Insert the plug into a 120V, 60Hz polar socket.
- Installation is now complete, light is operational.
Linking Multiple Shop Lights:
- Insert the lamp plug of the required link into the socket of the previous lamp on the side.
**NOTE: A maximum of 4 lamps can be connected. Max current is 1.41A.
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the
products listed are free from defects in material and/or workmanship only.
Maxxima will replace any warrantied product to the original consumer/purchaser
if the product fails because of defects due to workmanship and/or materials
within the limited warranty period. Limited warranty is not transferable and
applies to the original installation of the Maxxima product. This offer does
not constitute in any way a product guarantee and Maxxima does not hereby
assume any obligation whatsoever beyond sending a free replacement product.
info@maxximastyle.com
866-MAXXIMA (629-9462)
www.maxximastyle.com
125 Cabot Court Hauppauge, NY 11788
MSL-205000F
www.maxximastyle.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>