Solar Lighting DiRECT SLDPT4W/BLK-WW Post Top Instruction Manual
- August 12, 2024
- Solar Lighting DIRECT
Table of Contents
Solar Lighting DiRECT SLDPT4W/BLK-WW Post Top
Product Information
Specifications
- Model No.: SLDPT4W/BLK-WW
- Package Contents:
- 1 x Light Fitting
- 1 x Mounting Base
- 4 x Screws
- Features:
- Built in Photo Electric Cell (Day/Night Sensor)
- 6-8 hours Operation
- Flush Mounting Position
- Charging Time: 6 hours
Product Usage Instructions
Installation for 3 inch post:
- Remove contents from packaging.
- Choose your desired installation location ensuring maximum direct sunlight exposure.
- Open the battery cover underneath the fitting and remove the plastic tab to activate the fitting.
- Fix the Post Top directly on top of your post without using the base piece and secure with the supplied screws.
Installation for 4 inch post:
- Follow Steps 1-3 above.
- Install the mounting base to the top of your post using the supplied screws.
- Place your Post Top onto the mounting base and secure with the screws on either side.
Note: Ensure maximum direct sunlight exposure for efficient charging, especially on overcast/cloudy days to prevent early light shutdown.
FAQ
Troubleshooting
- Phenomenon: Light won’t turn on
- Cause: Switch hasn’t been turned on
- Inspection Method: Determine switch position
- Solution: Turn the switch on
- Phenomenon: Light only stays on for a short amount of time
- Cause: Battery has run flat
- Inspection Method: Charge the light in direct sunlight for 1-2 days
- Solution: Charge the battery in direct sunlight for 1-2 days with the switch off, then check again
If issues persist, contact SLD Customer Service at 1300 135 911 or visit www.solarlightingdirect.com.au for further assistance.
PACKAGE CONTENTS
- 1 x Light Fitting
- 1 x Mounting Base
- 4 x Screws
FEATURES
- Built in Photo Electric Cell (Day/Night Sensor)
- 6-8 hours Operation
- Flush Mounting Position
- Charging Time: 6 hours
Installation to suit 3 inch post
-
Remove contents from packaging
-
Choose your desired installation location. Please ensure that you situate your fitting where it will receive maximum direct exposure to sunlight throughout the day.
-
Open the battery cover on the underside of the fitting and remove the plastic tab. This will activate your fitting.
-
Without using the base piece, fix the Post Top directly on top of your post and secure using the supplied fixing screws.
Installation to suit 4 inch post -
Follow Steps 1-3 above
-
Install the mounting base to the top of your post using the supplied screws.
-
Then place your Post Top onto the mounting base and secure with the screws on either side.
IMPORTANT NOTES
- Please ensure you place your light in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT exposure.
- Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
- It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic day-night sensor triggering and result in your lights not turning on.
TROUBLESHOOTING
Customer Service Number: 1300 135 911
www.solarlightingdirect.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>