Solar Lighting DIRECT SLDWL01-BLK-WW Solar Powered Wall Light Instruction Manual

Table of Contents

Solar-Lighting-DIRECT-SLDWL01-BLK-WW-Solar-Powered-Wall-Light-
PRO

Specifications:

Model: SLDWL01/BLK-WW, SLDWL01/SIL-WW
Features:
- Built-in Photo Electric Cell (Day/Night Sensor)
- On/Off Switch
- 10-12 hours Operation per day
- Black/Silver P.C. Finish

Installation:

Remove contents from packaging
Locate desired wall for installation (ensure your desired location will receive maximum direct sunlight throughout the day)
Remove 2 grub screws to separate mounting plate from light
Secure mounting plate to wall using appropriate fixing screws
Secure light to mounting plate by reinstalling grub screws
Leave light switched OFF for 1-2 days
Switch light ON and your light will illuminate when it becomes dark

Important Notes:

Place the Solar Panel in a location where it can achieve a minimum of 6 hours of direct sunlight
Avoid installing the lights underneath a street light or porch light to ensure proper day/night sensor functioning
On overcast/cloudy days, the solar panel will still charge but may not reach full capacity

Troubleshooting:

Phenomenon: Light won’t turn on
Cause: Switch hasn’t been turned on or Battery has run flat
Solution: Turn the switch on or Charge the light in direct sunlight for 1-2 days then check again
Phenomenon: The light only stays on for a short amount of time
Cause: Low Battery or Battery Failure
Solution:
- Charge the battery in direct sunlight for 1-2 days with the switch off, then check again
- Clean the solar panel
- If the battery has matured, contact SLD Customer Service to buy new batteries

Frequently Asked Questions (FAQ):

Q: Can I install the lights under a streetlight?
A: It’s best not to install these lights underneath a street light as it may interfere with the automatic day/night sensor.
Q: How long should I charge the battery initially?
A: It is recommended to charge the battery in direct sunlight for 1-2 days before initial use.
Q: What should I do if my light doesn’t turn on?
A: Check if the switch is turned on and ensure the battery is charged by exposing it to direct sunlight for a couple of days.

Remove contents from packaging.
Locate desired wall for installation (insure your desired location will receive maximum direct sunlight throughout the day).
Step 1. Remove 2 grub screws to separate mounting plate from light.
Step 2. Secure mounting plate to wall using appropriate fixing screws.
Step 3. Secure light to mounting plate by re-installing grub screws.
Step 4. Leave light switched “OFF” for 1-2 days.
Step 5. Switch light “ON” and your light will illuminate when It becomes dark.

Solar-Lighting-DIRECT-SLDWL01-BLK-WW-Solar-Powered-Wall-
Light-1

IMPORTANT NOTES

Please ensure you place your Solar Panel in a location where it can achieve a minimum of 6-HRS DIRECT SUNLIGHT.
Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficient as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
It’s best not to install these lights underneath a street light, porch light, etc. because this may stop the automatic day-night sensor triggering and result in your lights not turning on.

Phenome non	Cause	Inspection Method
Light won’t turn on.	Switch hasn’t been turned on.	Determine what position
the switch is in.	Turn the switch on.
Battery has run flat.	Period of rainy or cloudy weather or installation site
doesn’t provide enough direct sunlight.	Charge the light in direct sunlight