Solar Lighting DIRECT SLDWL0026-PIR Modern Wall Light with Motion Sensor Instruction Manual
- June 1, 2024
- Solar Lighting DIRECT
Table of Contents
Solar Lighting DIRECT SLDWL0026-PIR Modern Wall Light with Motion Sensor
Product Information
Specifications:
- Pyro-electric Infrared Sensor
- Built-in Photo Electric Cell
- 1 minute Sensor Run Time
- 6-8 hours Operation per day
- Wall Mounting Bracket
- UV-Stabilised PVC Lens
Product Usage Instructions
Installation:
- Remove package contents.
- To locate the ON/OFF button, twist the solar panel head off the fitting, flip upside down, and find the button in the center. Switch your fitting ON via this button.
- Choose an installation location where the solar panel will receive a minimum of 6 hours of direct sunlight per day.
- Using the supplied screws, fix the light to your desired wall.
Instruction Guide:
- Residential Wall Lights
- Model No. SLDWL0026-PIR
Important Notes:
- Place your Solar Panel where it can achieve a minimum of 6 hours of DIRECT SUNLIGHT.
- On overcast/cloudy days, the solar panel will still charge but not as efficiently as sunny days.
- Avoid installing lights underneath street lights or porch lights to ensure automatic day-night sensor triggering.
Troubleshooting:
Phenomenon | Cause | Solution |
---|---|---|
Light won’t turn on | Switch hasn’t been turned on | Determine switch position |
and turn it on
The light only stays on for a short amount of time| Battery has run flat|
Charge the light in direct sunlight for 1-2 days
| Low Battery| Charge battery in direct sunlight for 1-2 days with switch off,
clean solar panel if needed
| Battery Failure| Contact Customer Service for battery replacement
Customer Service Number: 1300 135 911
www.solarlightingdirect.com.au
FAQ:
-
Q: How long does the battery last on a full charge?
A: The battery typically lasts for the specified 6-8 hours of operation per day when fully charged. -
Q: Can I install the light in a shaded area?
A: It is recommended to install the light where it can receive a minimum of 6 hours of direct sunlight for optimal performance. -
Q: What should I do if the light doesn’t turn on?
A: Check if the switch is turned on, and if the battery needs charging or replacement as per the troubleshooting guide.
PACKAGE CONTENTS
- 1 x Light Fitting
- 1 x Pack of screws
FEATURES
- Pyro-electric Infrared Sensor
- Built in Photo Electric Cell
- 1 minute Sensor Run Time
- 6-8 hours Operation per day
- Wall Mounting Bracket
- UV-Stabilised PVC Lens
INSTALLATION METHOD
- Remove package contents.
- To locate the “ON/OFF” button, twist the solar panel head off the fitting, flip upside down and the button is situated in the centre, switch your fitting “ON” via this button (See in FIGURE 1).
- Decide on your installation location where the solar panel will receive a minimum of 6 hours of direct sunlight a day.
- Using the supplied screws, fix the light to your desired wall.
- Remove protective membrane from solar panel (Seen in FIGURE 2) & your light is now ready to use
IMPORTANT NOTES
- Please ensure you place your Solar Panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT.
- Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
- It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic daynight sensor triggering and result in your lights not turning on.
TROUBLE SHOOTING
Customer Service Number: 1300 135 911
www.solarlightingdirect.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>