Solar Lighting DIRECT SLDGS0053-WW High Output Garden Spot Light RGB Instruction Manual
- June 1, 2024
- Solar Lighting DIRECT
Table of Contents
Solar Lighting DIRECT SLDGS0053-WW High Output Garden Spot Light RGB
Specifications
- Model: SLDGS0053-WW, SLDGS0053-CW, SLDGS0053-RGB
- Power Source: Solar Panel
- Light Levels: Low (Dim), High (Bright), Off
- Installation: Spike Mount
- Customer Service Number: 1300 135 911
- Website: www.solarlightingdirect.com.au
Product Usage Instructions
Installation
- Remove contents from packaging.
- Locate the ON/OFF power button on the back of your solar panel.
- Press the ON/OFF button once for the LOW level (Dim), press again for the HIGH level (Bright), and press a third time for OFF.
Spike Mount Installation
- Attach the mounting spike to the bottom of your light fitting.
- Adjust the solar panel using the swivel head to face direct sunlight for maximum sun exposure.
- Spike your garden light into soil or grass for installation.
Important Notes
- Place solar panels where it can receive a minimum of 6 hours of direct sunlight daily.
- Switch the light to LOW mode for longer illumination at night.
- Avoid installing lights under street lights or porch lights to prevent sensor issues.
FAQ
- Q: How can I increase the battery life of my solar light?
- A: Ensure the solar panel receives sufficient direct sunlight and switch the light to LOW mode for longer illumination.
PACKAGING CONTENTS
- 1 x Light Fitting
- 1 x Mounting Spike
- 1 x Pack of Screws
FEATURES
- Day/Night Sensor
- High/Low Brightness Setting
- 8 hours Operation per day
- Spike or Surface-Mount Option
- Adjustable Solar Panel
- Colour –Black
INSTALLATION METHOD
- Remove contents from packaging
- Locate the “ON/OFF” power button on the back of your solar panel
- Press the “ON/OFF” button once, and the light will be set to the “LOW” level (Dim). Press the button again and the light will be at a “HIGH” level (Bright). Press the button a third time and your light will be “OFF”
(Note, your light is packaged & transported with the power button in the “OFF” position).
Spike Mount Installation
Please refer to FIGURE 1 for the below steps
- Attach the mounting spike to the bottom of your light-fitting
- To ensure the panel is receiving maximum sun exposure, adjust the solar panel using the swivel head to face direct sunlight
- Spike your garden light into soil or grass and it is ready for use
IMPORTANT NOTES
- Please ensure you place your solar panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT
- If you wish for longer illumination throughout the night, switch the light to “LOW” mode
- Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficient as on a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
- It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic day-night sensor triggering and result in your lights not turning on.
TROUBLESHOOTING
CONTACT
- Customer Service Number: 1300 135 911
- www.solarlightingdirect.com.au.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>