Solar Lighting DIRECT SLDFL0004C-WW Solar Powered Flood Light with Motion Sensor Cool White Instruction Manual
- June 1, 2024
- Solar Lighting DIRECT
Table of Contents
Solar Lighting DIRECT SLDFL0004C-WW Solar Powered Flood Light with Motion Sensor Cool White
PACKAGING CONTENTS
1 x Light Fitting
1 x Solar Panel
1 x Mounted Bracket
1 x Pole Clamp
1 x Pack of Screws
LIGHTING MODES
ON – Light works Dusk to Dawn via solar panel
PIR – Light activates when PIR motion sensor is triggered (See FIGURE 1
for dial diagram)
TIME DIAL – Select short or long length of time light will remain on
after last movement is detected (5-40secs) (FIGURE 1)
SENS DIAL – Adjust dial to low or high sensitivity of the PIR sensor
(FIGURE 1)
INSTALLATION METHOD
- Remove contents from packaging
- Locate the “ON/OFF/PIR” power switch on the underside of the fitting and select your desired working mode
(Note, your light is packaged & transported with the power switch in the “OFF” position)
ASSEMBLY & INSTALLATION
Light Fitting
- Fix mounting plate by drilling 3 holes in selected wall
- Using the supplied screws, attach the light fitting by drilling the fitting to the mounting plate (FIGURE 1)
- To adjust the angle of the light, turn the swivel head
Solar Panel
If mounting your solar panel on a pole/post:
-
Connect your solar panel to the metal clamp using the supplied screws (FIGURE 2)
-
Bring the black clamp base through the metal clamp and tight to the bottom of the pole
-
Using the screw on the thread of the metal clamp, tighten so the clamp base is hard against the pole (FIGURE 3)
IMPORTANT NOTES
- Please ensure you place your solar panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT
- Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
- It’s best not to install the fitting under a street light, porch light or similar as this may stop the automatic day-night sensor triggering and result in your lights not turning on
TROUBLE SHOOTING
| Phenomenon | Cause | Inspection Method | Solution |
|---|---|---|---|
| Light won’t turn on | Switch hasn’t been turned on | Determine what position the | |
| switch is in | Turn the switch on | ||
| Battery has run flat | Period of rainy or cloudy weather or installation site | ||
| doesn’t provide enough direct sunlight | Charge the light in direct sunlight |
for 1-2 days then check again
The light only stays on for a short amount of time| Low Battery|
- Bad installation site for the solar panel
- Dust or leaves are covering the panel
- Long period of overcast weather
|
- Charge the battery in direct sunlight for 1-2 days with the switch off, then check again
- Clean the solar panel
Battery Failure|
- Access the light and & replace battery
- Battery has matured
| Contact SLD Customer Service to buy new batteries
CUSTOMER SUPPORT
Customer Service Number: 1300 135 911
www.solarlightingdirect.com.au
Model No.SLDFL0004C-WW, SLDFL0004C-CW
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>