Solar Lighting DIRECT SLDBL0026B-WW Modern Garden Bollard Instruction Manual

Solar Lighting DIRECT SLDBL0026B-WW Modern Garden Bollard

Product Information

Specifications

• Model: SLDBL0026B-WW
• Package Contents:

1. 2 x Light Fittings
2. 2 x Ground Spikes

• Features:

1. Built-in Photo Electric Cell
2. 8-12 hours Operation per day
3. Spike Mounted

Product Usage Instructions

Installation Method

1. Remove contents from packaging.
2. To locate the ON/OFF switch, twist the solar panel head off the fitting and flip upside down (Refer to FIGURE 2).
3. Switch your fitting into the ON position.
4. Decide on your installation process, either Surface mount or Spike mount.
   • Spike Mount: Remove spike from the post & press into the underside to enable you to spike the light into soil or grass.
   • NOTE : The Spike Mount is located INSIDE the bollard post. The piece inside the bottom must be inverted (Refer to FIGURE 1).

Important Notes

• Please ensure you place your solar panels in a location where they can achieve a minimum of 6 hours DIRECT SUNLIGHT.
• Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
• It’s best not to install these lights underneath a street light, porch light, etc. because this may stop the automatic day-night sensor triggering and result in your lights not turning on.

Troubleshooting

Phenomenon: Light won’t turn on

Cause

• Switch hasn’t been turned on
• Battery has run flat

Inspection Method: Determine what position the switch is in

Solution

• Turn the switch on
• Charge the light in direct sunlight for 1-2 days then check again

Phenomenon: The light only stays on for a short amount of time

Cause

• Low Battery
• Battery Failure

Solution

• Bad installation site for the solar panel
• Dust or leaves are covering the panel
• Long period of overcast weather

Contact SLD Customer Service at 1300 135 911 or visit www.solarlightingdirect.com.au for further assistance.

Frequently Asked Questions (FAQ)

Q: How long does the battery last on a full charge?
A: The battery typically lasts for 8-12 hours of operation per day, depending on sunlight exposure and usage.

INSTRUCTION GUIDE

Residential Bollards
Model No. SLDBL0026B-WW

PACKAGE CONTENTS

1. 2 x Light Fittings
2. 2 x Ground Spikes

FEATURES

1. Built in Photo Electric Cell
2. 8-12 hours Operation per day
3. Spike Mounted

INSTALLATION METHOD

1. Remove contents from packaging
2. To locate the “ON/OFF” switch, twist the solar panel head off the fitting and flip upside down (See in FIGURE 2)
3. Switch your fitting into “ON” position
4. Decide on your installation process, either Surface mount or Spike mount

Spike Mount
Remove spike from the post & press into the underside to enable you to spike the light into soil or grass

NOTE: The Spike Mount is located INSIDE the bollard post. The piece inside the bottom must be inverted (See FIGURE 1)

IMPORTANT NOTES

• Please ensure you place your solar panels in a location where the y can achieve a minimum of 6HRS DIRECT SUNLI GHT
• Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified
• It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic day-night sensor triggering and result in your lights not turning on

TROUBLESHOOTING

Phenomenon| Cause| Inspection

Method

| Solution
---|---|---|---

Light won’t turn on

| Switch hasn’t been turned on| ****

Determine what position the switch is in

| ****

Turn the switch on

Battery has run flat| Period of rainy or cloudy weather or installation site doesn’t provide enough direct sunlight| **** Charge the light in direct sunlight for 1-2 days then check again

The light only stays on for a short amount of time

| ****

Low Battery

|

1. **** Bad installation site for the solar panel
2. Dust or leaves are covering the panel
3. Long period of overcast weather

|

1. 1. Charge the battery in direct sunlight for 1-2 days with the switch off, then check again
2. Clean the solar panel

**** Battery Failure|

1. Access the light and & replace battery
2. Battery has matured

| **** Contact SLD Customer Service to buy new batteries

Customer Service Number: 1300 135 911
www.solarlightingdirect.com.au

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>