Solar Lighting DIRECT SLDWL0027-PIR Modern Wall Light Instruction Manual

: June 1, 2024
: Solar Lighting DIRECT

Table of Contents

Solar Lighting DIRECT SLDWL0027-PIR Modern Wall Light
Product Usage Instructions
FAQ
PACKAGE CONTENTS
FEATURES
INSTALLATION METHOD
IMPORTANT NOTES
TROUBLE SHOOTING
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Solar Lighting DIRECT SLDWL0027-PIR Modern Wall Light

Specifications

Model: SLDWL0027-PIR
Features:
- Pyro-electric Infrared Sensor
- Built-in Photo Electric Cell
- 1 minute Sensor Run Time
- 6-8 hours Operation per day
- Wall Mounting Bracket
- UV-Stabilised PVC Lens

Product Usage Instructions

Installation Method

```
1. Remove package contents.
```
To locate the ON/OFF button, twist the solar panel head off the fitting, flip over, and find the button in the center. Switch your fitting ON via this button (See in FIGURE 1).
Choose an installation location where the solar panel will receive a minimum of 6 hours of direct sunlight per day.
Using the supplied screws, fix the light to your desired wall.

Instruction Guide

Residential Wall Lights Model No. SLDWL0027-PIR

Important Notes

Please ensure the Solar Panel receives a minimum of 6 hours of direct sunlight daily.
On overcast/cloudy days, the solar panel will still charge but less efficiently. Light may turn off earlier than specified.
Avoid installing lights under street lights or porch lights to prevent sensor issues.

Troubleshooting

Phenomenon	Cause	Solution
Light won’t turn on	Switch hasn’t been turned on	Determine switch position

and turn it on
The light only stays on for a short amount of time| Battery has run flat or low battery| Charge in direct sunlight for 1-2 days or replace battery

Final Steps

Remove protective membrane from solar panel (Seen in FIGURE 2).
Your light is now ready to use.

Customer Service Number: 1300 135 911

www.solarlightingdirect.com.au

FAQ

Q: How do I know if my light is fully charged?

A: The light will operate for the specified duration when fully charged under direct sunlight for the recommended period.

Q: Can I replace the battery myself?

A: Yes, you can replace the battery by following the instructions provided in the troubleshooting section or contact customer service for assistance.

PACKAGE CONTENTS

1 x Light Fitting
1 x Pack of screws

FEATURES

Pyro-electric Infrared Sensor
Built in Photo Electric Cell
1 minute Sensor Run Time
6-8 hours Operation per day
Wall Mounting Bracket
UV-Stabilised PVC Lens

INSTALLATION METHOD

Remove package contents
To locate the “ON/OFF” button, twist the solar panel head off the fitting, flip over and the button is situated in the centre, switch your fitting “ON” via this button (See in FIGURE 1)
Decide on your installation location where the solar panel will receive a minimum of 6 hours of direct sunlight a day
Using the supplied screws, fix the light to your desired wall
Remove protective membrane from solar panel (Seen in FIGURE 2) & your light is now ready to use

IMPORTANT NOTES

Please ensure you place your Solar Panel in a location where it can achieve a m inimum of 6HRS DIRECT SUNLIGHT
Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic day-night sensor triggering and result in your lights not turning on