Amerock BPR2811C1314 Concealed Hinge Instruction Manual
- June 12, 2024
- Amerock
Table of Contents
Amerock BPR2811C1314 Concealed Hinge
Product Information
The Concealed Hinge BPR2811C1314 is a cabinet hinge manufactured by Amerock. It is designed to be used with face frame cabinets and is suitable for cabinet doors. The hinge is made of durable materials and provides smooth and reliable operation. The hinge comes with installation instructions and the necessary hardware for mounting. It offers multiple adjustment options for door height, side-to-side positioning, and in-and-out positioning, allowing users to achieve the desired fit and alignment.
Product Usage Instructions
- Mark hole locations on the back of the cabinet door as shown in Figure 1. Use the appropriate drill bits to drill three holes at these locations, ensuring they are 7/16 inches (11mm) deep. Be careful not to drill all the way through the cabinet door.
- After installing the hinges onto the cabinet door, align the door in the desired position. Mark holes for each mounting location on the cabinet frame. Use a 1/8 drill bit to drill pilot holes for frame mounting screws.
- Place the door in position and attach it to the frame using screw B.
- For adjustments:
- Height Adjustment: With the door installed, loosen all mounting screws A, adjust the door height, and re-tighten the screws.
- Side-to-Side Adjustment: With the door installed, rotate cam screw B to adjust the left-to-right door positioning.
- Depth Adjustment: With the door installed, rotate cam screw C to adjust the in-and-out door positioning.
Note: The recommended weight and size ranges provided are for reference
only. It is suggested to perform trial mountings to ensure optimal
performance.
For any further assistance or inquiries, please contact Amerock customer
support at 800-435-6959 or
amerock.customersupport@amerock.com.
More information can also be found on the Amerock website at
www.amerock.com.
Items Included
Overlay
Tools Required
Recommended Number of Hinges Per Door Size **
**
Note:
These are recommendations only. Trial mountings are suggested.
Door Preparation
Mark hole locations on the back of the cabinet door, as shown in Figure 1. At these locations, using the appropriate 2 drill bits, drill 3 holes that are 7/16” (11mm) deep. Be careful not to drill all the way through the cabinet door. **
**Install hinges onto the door by pressing hinge dowels fully into their corresponding holes.
Frame Preparation
- A After installing hinges onto the cabinet door, align the door in the desired position. Mark holes for each mounting location on the cabinet frame. Use a 1/8” drill bit to drill pilot holes for frame mounting screws.
- B Place the door in position, and attach door to frame using screw B.
Adjustment
- A Height Adjustment: With the door installed, loosen all mounting screws A, adjust door height, and re-tighten screws.
- B Side-to-Side Adjustment: With the door installed, rotate cam screw B to adjust left-to-right door positioning.
- C Depth Adjustment: With the door installed, rotate cam screw C to adjust in-and-out door positioning.