BEGA 50 830.6 Studio Line Floor Lamp for Indoor Use Instructions
- June 3, 2024
- BEGA
Table of Contents
BEGA 50 830.6 Studio Line Floor Lamp for Indoor
Floor lamp for indoor use
Instructions for use
Application
Floor lamp · indoor luminaire with impact-resistant synthetic diffuser and
metal housing for shielded light, deflected upwards and downwards.
Product Description
Floor lamp »STUDIO LINE«
Metal housing, finish Colour velvet white
Aluminium housing shield,
Finish Colour velvet white inside hue matt copper
Impact-resistant synthetic cover, translucent white
Foot dimmer for infinite light adjustment
White connecting cable · 2 m, with safety plug
LED power supply unit
220-240 V y 50-60 Hz
Safety class I
c – Conformity mark
Weight: 10.5 kg
This product contains light sources of energy efficiency classes D
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we
recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.
Lamp
- Module connected wattage 35 W
- Luminaire connected wattage 39 W
- Rated temperature ta = 25 °C
- Ambient temperature ta max = 50 °C
50 830.6 K3
- Module designation 2x LED-1226/930
- Colour temperature 3000 K
- Colour rendering index CRI > 90
- Module luminous flux 5630 lm
- Luminaire luminous flux 2099 lm
- Luminaire luminous efficiency 53,8 lm / W
Installation
LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during
installation or relamping.
Carefully remove the floor lamp from its packaging and set it up. Make sure
that the luminaire is in a firm and secure position.
Guide the luminaire shield provided over the synthetic cover of the luminaire
and adjust it inits end position.
Connect luminaire to mains supply (230 V).
Press foot dimmer gently to turn the luminaire on or off.
Holding the sensing device enables to adjust the light intensity infinitely.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
We recommend that you dry-clean the fool dimmer.
Replacing the LED module
- The designation of the LED module is noted on a label in the luminaire.
- The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by qualified persons using standard tools.
- Disconnect the system and open the luminaire.
- Please follow the installation instructions for the LED module.
- Defective luminaire cover must be replaced.
- Close the luminaire.
Spares
- LED power supply unit DEV-0139/1050
- Connecting cable with foot dimmer 62 001 238
- LED module 3000 K LED-1226/930
- Housing shield 71 003 344 B6
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>