ORTECH FM1-7-5CCT LED Flush Mounts Instruction Manual

: August 4, 2024
: Ortech

Table of Contents

Instruction Manual
LED Flush Mounts
MODEL FM1-7-5CCT | FM1-9-5CCT | FM1-12-5CCT

Instruction Manual

LED Flush Mounts

MODEL FM1-7-5CCT | FM1-9-5CCT | FM1-12-5CCT

WARNING

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

LED Flush Mounts are suitable for using in damp locations
Please keep the LED Flush Mounts away from any corrosive substance, and please use dry cloth when you clean it
LED Flush Mounts can only be installed by a qualified electrician
Before installation or maintenance, please disconnect the power to prevent electric shock

Application Notice

RISK OF SHOCK — House electric current can cause painful shock or serious injury unless handled properly. For your safety, always remember to:
A) Turn OFF the power supply at the fuse or circuit breaker box before you install the fixture
B) Double-check all connections to be sure that they are tight and correct
This fixture is designed for use in a circuit protected by a fuse or circuit breaker. It is also designed to be installed in accordance with local electrical codes. If you are unsure about your wiring, consult a qualified electrician or local electrical inspector, and check your local electrical code
RISK OF CUTS — some metal parts in the fixture may have sharp edges. To prevent cuts and scrapes, wear gloves when handling the parts
Account for small parts and destroy packing material, as these may be hazardous to children
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person
Terminal block and the suspending accessories are not included. Installation must be performed by a qualified person

CAUTION

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES. Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.

INSTALLATION GUIDE

Tools Required

Phillips Screwdriver Wire Cutters Pliers Wrench

OPTION1: FLUSH MOUNT

Fig. 1

a: Electrical Junction Box
b: Mounting Plate
c: Mounting Screws

1. Pull the supply wires and house ground wire from the Outlet Box. Position the mounting plate over the Junction Box. Mark the location of the two holes located on the Mounting Plate. Be sure to mark only the narrow parts of the hole. Removeing Plate from the ceiling. Drill the two holes using the appropriate type and size drill bit. Insert anchors into the holes. ( See Fig.1)

Fig. 2

a: Black
b: White
c: Ground
d: SCCT switch

2. Wire Connections: Connect the house ground wire to the fixture ground wire; connect the white supply wire to the white fixture wire; connect the black supply wire to the black fixture wire by using the wire connectors. Carefully tuck all wires back into the Junction Box.
Adjust the 5CCT switch ( See Fig.2.)

Fig. 3

3. Snap and fix the clip in the bracket. ( See Fig . 3)

Fig. 4

4. Turn on the power and Light up the lamp. ( See Fig . 4 )